Enhanced hearing

Good morning!

I'm trying to make an enhanced hearing circuit (kinda like Superman).
For my conceptual design, I read some of the tips I've gathered from
various postings in this group and also from various readings. So far,
I've come up with a crude concept:

- Audio input coming from a small microphone (electret-type?)
- Output from microphone is AC coupled to a voltage follower / buffer
audio op amp
- Audio op amp buffer is single supply so i will need a virtual ground
in one of the input pins that will be approximately 1/2 of the supply
voltage
- From the two steps above, I'm assuming that I won't have any control
of the DC level bias from the microphone output

- My buffered signal would then be split two ways... i'm assuming i can
just connect the buffered output to two different op amp inputs... part
of the signal will be sent to a level detector and the other part would
be the actual hearing enhancement gain op amp


- The level detector part would probably consist of an active rectifier
with a unity gain with its output being sent to a comparator.... the
output of this comparator would somehow interface to the gain op amp so
I can adjust the gain if the audio level input is too high... i saw an
active rectifier circuit in the Arts of Electronics book, so I think I
can use that one.

- The gain part would consist of an audio op amp with a variable
resistor for gain adjustment... but then this is where I get stuck. For
the gain section, I do not know how I can amplify my audio signal
without amplifying the DC component.

Since I do not have that much experience in electronic design compared
to others here, I was hoping maybe you, the experienced ones, can help
me answer the following questions:

1). How can I amplify an audio signal correctly without clipping the
output if I use a single-supply configuration?

2). How can I interface the level detection portion with the gain
portion? (I was thinking maybe I can use some sort of "voltage
controlled resistor" if there is one as part of my gain feedback
scheme).

3). What parameters would dominate my choice of parts for this type of
application? (I'd like this to be battery powered, so I'm assuming I
need some sort of low voltage, low power op amps. But I do not know how
to spec out the microphone and headphones for battery applications.)

4). How many questions can I ask before you guys/gals get sick of me?

Thanks!

.

Relevant Pages

  • Re: Enhanced hearing
    ... Audio input coming from a small microphone ... Audio op amp buffer is single supply so i will need a virtual ground ... with a unity gain with its output being sent to a comparator.... ... repetitive signals to pull them out of noise. ...
    (sci.electronics.design)
  • Re: Enhanced hearing
    ... Audio input coming from a small microphone ... Audio op amp buffer is single supply so i will need a virtual ground ... The level detector part would probably consist of an active rectifier ... with a unity gain with its output being sent to a comparator.... ...
    (sci.electronics.design)
  • Re: Time for some humble pie...
    ... Except that there are credible reasons why one amp could really sound different ... Which may have only a glancing relations to reality. ... newfound consciousness and audio system!" ... If you found that to be true, would it amount to a gain in wisdom? ...
    (rec.audio.opinion)
  • Re: Cranky Op-Amp
    ... but it's in the audio frequency ... The op-amp may work great, ... the long output cable the amp is still cranky. ... A gain of 83, ...
    (sci.electronics.basics)
  • Re: I think I need channel filters - ok fixed it
    ... quite small - starting from those levels you'd need the overall downstream gain to be between -3 and +6 dB to keep to recommended signal levels at the outlets. ... I am driving four outlets via a passive splitter, and have the masthead amp on close to max gain. ... The digiboxes are reporting approx 40% signal strength, but channel quality is at least 85% or better. ...
    (uk.tech.digital-tv)