Re: ? How to stabilize a cheap colpitts oscillator


"Phil Allison" <philallison@xxxxxxxxxx> wrote in message
news:4vm79dF1chnnrU1@xxxxxxxxxxxxxxxxxxxxx

"Dave"


** This is getting silly and tedious.

DESCRIBE YOUR TEST GEAR FULLY !!




I apologize, the freq counter is a Schlumberger 1252, and the scope is a
Tek 2335 100MHz dual-trace, but I am only using one channel. I honestly
don't kow what else to tell you about the test equipment.



** I asked you to DESCRIBE the items - not merely list the model
numbers.

What is the frequency range of the counter (Goolge supplied no hits on the
model number) .

Die it have a trigger control or bandwidth filters ?

Why cannot YOU tell ME if the scope trace shows harmonics in the wave
form ?




....... Phil



The counter goes up to at least 100 MHz, but that's all I know. The trace
on the scope is clean. Again, I apologize, but I don't know what to tell
you. I am still fairly new to RF, and am learning as I go along... If you
have a question, please ask. This is why I am asking for help...

Dave


.

Relevant Pages

  • Re: Telephony question
    ... >First I would like to apologize if this is outside of the scope of this ... >group but any helpful hints you could give me is greatly appreciated. ... You could configure Asterisk to do that ...
    (comp.dcom.telecom.tech)
  • Telephony question
    ... First I would like to apologize if this is outside of the scope of this ... group but any helpful hints you could give me is greatly appreciated. ... Prev by Date: ...
    (comp.dcom.telecom.tech)
  • Re: ? How to stabilize a cheap colpitts oscillator
    ... Dave wrote: ... on the scope is clean. ... Again, I apologize, but I don't know what to tell you. ...
    (sci.electronics.design)
  • Re: measuring distortion
    ... No way a scope trace can give that sort of info. ... I have found that looking at the output of the analyser ...
    (rec.audio.tubes)
  • Re: ? How to stabilize a cheap colpitts oscillator
    ... I apologize, the freq counter is a Schlumberger 1252, and the scope is a ... Tek 2335 100MHz dual-trace, but I am only using one channel. ... Why cannot YOU tell ME if the scope trace shows harmonics in the wave ...
    (sci.electronics.design)