Re: Running Copper Clad Kapton Through Laser Printer

Thus spake D from BC:

After chemical wash (looks like sh*t!)

Might a clothes iron do the job? The common method of making a laser printer
PCB (last time I Googled this) is to use hard-coated (shiny) paper with the
(reverse-printed) PC image and to transfer the image onto a cleaned copper
PCB using a hot iron on the back of the paper. This melts the toner onto the
copper.

Maybe find some non-stick material (is teflon smooth enough?) to lay over
your copper foil when it emerges from the printer and by heating, better melt
the toner to the foil. Or maybe just put the foil with image into the oven
for a few minutes? Seems that higher temperature is all that might be needed
to make it stick better...

Great concept.

Good luck,
--
John English

.

Relevant Pages

  • Re: Running Copper Clad Kapton Through Laser Printer
    ... Might a clothes iron do the job? ... The common method of making a laser printer ... PCB using a hot iron on the back of the paper. ... the toner to the foil. ...
    (sci.electronics.design)
  • Re: Easy and fun: Worlds smallest FPGA module.
    ... Replacing the paper in Laser printer with the catalog paper." ... EUR for the fine aetz kristall (for acid making) ... EUR for 20 bx 30 cm PCB ... PS I will post the picture of my first board to my website as soon as get ...
    (comp.arch.fpga)
  • Re: PCB maker
    ... >I would like to use the photographic process to PCB. ... artwork printed in reverse on acetate laser printer film. ...
    (sci.electronics.design)
  • Re: pcb printing
    ... >photoresist & laser printed transparencies etc. ... >I have the laser printer already, and I did a test to check its ... will vertical stretching of the board layout by 7% ... pcb company to do you some photoplots. ...
    (sci.electronics.design)