Re: pic micro programming

In article <1174208884.436491.185070@xxxxxxxxxxxxxxxxxxxxxxxxxxxx>,
eddition99@xxxxxxxxxxx says...
On Mar 16, 11:50 am, krw <k...@xxxxxxxxxx> wrote:
In article <1174070376.509839.179...@xxxxxxxxxxxxxxxxxxxxxxxxxxx>,
edditio...@xxxxxxxxxxx says...> i am trying to program a pic16f877 to desplay the rpm of a motor. I
am using a sensor on the shaft to give me 4 puls per revolution. I am
thinking of using capture and compare facility of the pic. or some
timer . can anyone help me

Sure. There is a <shift> key at each bottom, outside corner of your
keyboard. You might try a spelling checker too.

--
Keith

If you are so smart how comes you dont realize that am not asking help
for some minor Grammatical error.

Well, since you asked... I gave help where it was most needed.

--
Keith
.

Relevant Pages

  • Re: pic micro programming
    ... thinking of using capture and compare facility of the pic. ... timer. ... There is a <shift> key at each bottom, ...
    (sci.electronics.design)
  • Re: pic micro programming
    ... thinking of using capture and compare facility of the pic. ... you can count pulses over a measured time interval (using a timer) ...
    (sci.electronics.design)
  • Re: How to make click button but not taking focus
    ... VAR firstRepeat && Flag, if first repeat timer message ... Retrieve the keyboard delay information ... After creation a button does not capture and does not autorepeat ...
    (microsoft.public.win32.programmer.ui)
  • BSCAN_SPARTAN3 proper use with CAPTURE and UPDATE
    ... "a little" difficult (instead less functional DRCKx signals are provided). ... the DRCKx does not work when CAPTURE or UPDATE are active, ... the 18-bit data register, BTW - either BSCAN... ... -- Load and shift data ...
    (comp.arch.fpga)
  • Re: Employee Time Sheet Question
    ... The problem with the calculation is that by NOT ... I would use two UNBOUND fields to capture the TIME IN and TIME OUT and then use code to set the values of the BOUND controls. ... You may also want to add a warning/confirmation message when the value of TIME OUT is earlier than TIME IN to confirm that the shift spanned midnight. ... but I'm not getting the right totals back. ...
    (microsoft.public.access.modulesdaovba)