The Education of MassiveProng (Pt 3 of 275) (001/634) (165/634)



1930 is connected to a further power supply connector 1932. A
power-channeling circuit 1936 is connected to both supply connectors
1904 and 1932 and to power input RTCPTR of PPU 110. Power-channeling
circuit 1936 has a pair of diodes 1942 and 1944 connected together at
their cathodes and therefrom to power input RTCPWR. Diodes 1942 and
1944 also have their anodes connected separately to connector 1904 for
supply 172 and to connector 1932 via a drain-limiting resistor 1946
for coin cell 1930.

Power management logic circuit section 920B has logic (in circuitry
.



Relevant Pages

  • Re: Quick note for BDS owners
    ... each BDS box is inspected and tested at full load. ... You'll see that the circuit board pads are quite ... small because of the design of the TA4M connector. ... combine pins 1&2 and pins 3&4 for improved strength, redundancy, and ...
    (rec.arts.movies.production.sound)
  • Re: Brief overdrive
    ... Oddly, it reminded me of an earlier circuit, but I was not sure why. ... At the front end I used a pair of 6EJ7's as the diff amp. ... the 56 K resistor R37. ... input connector. ...
    (rec.audio.tubes)
  • Re: Differential amplifier Debugging
    ... The circuit worked fine and room temperature and then i inserted it ... resistance from VDD to GND pin, ... available to me on the connector: ...
    (sci.electronics.design)
  • Re: CFTBL ramp light chase board....out of ideas!! Please Help!
    ... Not too familiar with the circuit so make sure ... are controlled from connection J3 on the chase light board. ... J4 connector is working that it's getting voltage, ...
    (rec.games.pinball)
  • Re: Return Loss Bridge Accuracy Questions
    ... But even at 30 MHz a reasonably good microwave 50 ohm load gives only ... connector is an SO-239), and is enclosed in a shielded box. ... the three 50 ohm resistors is made of two 100 ohm 1206 chip resistors ... Has anyone with experience with this circuit any suggestions for how to ...
    (rec.radio.amateur.homebrew)