Re: Coil EMF volt vs current

On Thu, 03 May 2007 16:05:56 -0700, John Larkin wrote:
On Fri, 04 May 2007 08:21:17 +1000, Mike Lennis
On Thu, 03 May 2007 08:30:07 -0700, John Larkin
On Thu, 03 May 2007 19:40:37 +1000, Mike Lennis

Given the same solenoid, and assuming a fixed available wattage, what
proportion of 1) voltage vs. 2) current produces the highest possible
field strength?

How is this determined?

The coil has a resistance, and that resistance fixes the relationship
between the current and the voltage. So you can't vary them
independently, so your question is sort of meaningless.

As the voltage goes up, the current goes up, and there is a single,
unique voltage:current that dissipates the available watts.

Yes, very sorry. The fixed coil resistance was an error on my part.

What I am driving at is this. Given the same signal source, consumed
wattage can be increased by 1) lowering the coil resistance OR 2)
applying higher voltage.

Which of the two is preferrable for maximum field strength?

For example, in the extreme case, one could have microvolts (low
resistance coil) and tons of current, or heaps of voltage (high
resistance coil) and negligible current. Yet the wattage is the same.

What is the trade-off point for these two variables, ie. practical
solution?

Ampere-turns make magnetic field. For a given available wire winding
volume, the external surface area determines the cooling, so the watts
you can dump into a given coil geometry, for a given temperature rise,
is fixed.

Unless, of course, you've got some superconductor wire. ;-)

Cheers!
Rich

.

Relevant Pages

  • Re: Coil EMF volt vs current
    ... between the current and the voltage. ... wattage can be increased by 1) lowering the coil resistance OR 2) ... Since power is E^2/R, ...
    (sci.electronics.design)
  • Re: Coil EMF volt vs current
    ... proportion of 1) voltage vs. 2) current produces the highest possible ... between the current and the voltage. ... wattage can be increased by 1) lowering the coil resistance OR 2) ...
    (sci.electronics.design)
  • Re: Coil EMF volt vs current
    ... The coil has a resistance, and that resistance fixes the relationship ... between the current and the voltage. ... The fixed coil resistance was an error on my part. ... will, however, also have infinite inductance, so the field will take ...
    (sci.electronics.design)
  • Re: Ignition Coil Overheat
    ... decreasing of the current though it will cause a voltage drop. ... One part number ignition coil fits two vehicles of the same make, ... want to review Ohm's law. ... divided by current = resistance), or I*R = E (current times resistance ...
    (rec.autos.tech)
  • Re: Coil EMF volt vs current
    ... proportion of 1) voltage vs. 2) current produces the highest possible ... Field strength is entirely determined by the current through the coil. ... The effects of multiple current flows ...
    (sci.electronics.design)
Quantcast