Glue figure 8 wire x 2

Could I have a few suggestions on what type of commercial adhesive
would work best to permanently glue two lengths of insulated figure 8
wire on top of each other?

The bond must be continuous and flexible over 30 metres, so that rules
out hot melt, ties, heat shrink, etc.

Ideally, something that holds when pressed and then dries. Maybe a
clear contact type, or something like PVC pipe cement that melts the
plastic together.

Does anyone have any experience with this type of thing.

Ken Webber
.

Relevant Pages

  • Re: Glue figure 8 wire x 2
    ... would work best to permanently glue two lengths of insulated figure 8 ... The bond must be continuous and flexible over 30 metres, ... out hot melt, ties, heat shrink, etc. ... Is "figure 8 wire" a thing itself, or something you are doing to other ...
    (sci.electronics.design)
  • Re: Glue figure 8 wire x 2
    ... would work best to permanently glue two lengths of insulated figure 8 ... The bond must be continuous and flexible over 30 metres, ... out hot melt, ties, heat shrink, etc. ... Is "figure 8 wire" a thing itself, or something you are doing to other ...
    (sci.electronics.design)
  • Re: Glue figure 8 wire x 2
    ... would work best to permanently glue two lengths of insulated figure 8 ... The bond must be continuous and flexible over 30 metres, ... out hot melt, ties, heat shrink, etc. ... Is "figure 8 wire" a thing itself, or something you are doing to other ...
    (sci.electronics.design)
  • Re: Wire wrap
    ... >intended to wind transformers and so on. ... >insulation will melt and presto: ... >special wire available for this purpose in different colors. ... Just make sure you are ventilating the fumes away. ...
    (sci.electronics.design)
  • Re: Glue figure 8 wire x 2
    ... wire on top of each other? ... out hot melt, ties, heat shrink, etc. ... you may have to tie cables the wires while it cures ... (by experiments bending zip-cord sideways I estimate 20 times stiffer) ...
    (sci.electronics.design)