Re: proper response?

John Larkin wrote:
I just finished designing another board, a waveform generator, and I
asked one of my guys, my most-recent hire actually, to look it over
before we gerber it. He said "I really don't have my head into what I
was doing, so I'll take a day or so and give it a full check assuming
that it was designed by an idiot."

What should I have replied to a statement like that?

John

Nothing. Just let him solve the problems if any. Seems that he is long enough in designs not to jump with "I know, I know!" of greenhorns.
And his attitude may prove itself in the end. Who can say?

Enjoy

Stanislaw
.

Relevant Pages

  • Re: snow in... NEW ORLEANS!
    ... control designer and had a 10 year small business doing custom designs. ... are you the John Larkin from Fullerton? ... Do you know of TANO Corp, ...
    (sci.electronics.design)
  • Re: snow in... NEW ORLEANS!
    ... control designer and had a 10 year small business doing custom designs. ... are you the John Larkin from Fullerton? ... Do you know of TANO Corp, ...
    (sci.electronics.design)
  • Re: pcb fabrication
    ... you normally send designs in Gerber format. ... Download a free Gerber viewer to verify the output is what you expect. ... One further comment about batchpcb -- the default gerber output from ...
    (sci.electronics.basics)
  • Re: pcb fabrication
    ... so I can send designs to a manufacturer ... in gerber format Does anyone have recommendations about how ... and only stepping up what I designs when I'm sure that what I ... testing as a service) is take the gerber file and feed it into the PCB ...
    (sci.electronics.basics)
  • Re: ESR Meter - Roll your own - ESRrev0.JPG
    ... John Larkin wrote: ... the goofy and truly terrible "esr" meters we've seen here lately. ... but your designs and ideas are so ... You show us an esr meter that doesn't require a VMX crate. ...
    (sci.electronics.design)