Re: Low drift OP amp for photodiode circuit

garnet wrote:

I'm not up to date with the latest op amp technology and was wondering
what are the lowest drift op amps available now without using an oven.
This is for a photodiode circuit for low level light measurement.

Opamps with very low input currents have been available
for a very long time; you don't really need the latest
part for that task, unless you want to operate at low
supply voltages, with very low supply currents, etc.

One class of opamps well worth mentioning are NSC's
inexpensive CMOS opamps, e.g., their LMC6001A. This
one is 100% tested to insure that each chip has input
leakage currents of less than 0.025 pA, or 25fA, as we
like to say. These have a reasonably-low input offset
voltage of 350uV max.

Note, the LMC6001A was introduced at least 12 years ago
(I have a 1995 data*** in my computer's collection).

Normally if you want to measure very low light levels
(very small photodiode currents) you'll just use a high-
value feedback resistor to develop a signal voltage above
the opamp's offset voltage. For example, with a modest
100G resistor you can measure down to say 5fA and develop
a 0.5mV output signal. Using the LMC6001A, which has up
to 0.25mV of offset voltage and up to 2.5mV developed from
input leakage current across 100G, you could improve your
measurement range by noting the dark value and observing
the difference when you turned on your weak light.

Note, 5fA of photodiode current would mean you're observing
only 10fW of light, using a 0.5A/W silicon detector rating.

If you can chop your light, you can go even lower with a
lock-in amplifier.

If you're not inclined to use a high-value transresistance
feedback resistor like 50 to 200G, but instead want to use
say no more than 1000M, you could use a CMOS chopper-input
opamp with 5uV or less of input offset voltage. There have
been some interesting new parts in that area.

.