Re: Ethernet on fiber

Martin Griffith wrote:

One method is to use a Wavelength division multiplexing, basically
combining, optically, two signals of different colours. It can be
expensive, e.g.
http://www.bb-elec.com/product_family.asp?FamilyId=11&TrailType=Sub&Trail=6


Thanks, your link is very useful.

Marco / iw2nzm
.

Relevant Pages

  • Re: Reduce color saturation
    ... martin griffith wrote: ... Hmmm, since there is no luminance signal, just 3 color signals, it ... I've used generally used RGB to the Camera control units, ... used on the video gain control for the Microdyne 700 series receiver. ...
    (sci.electronics.design)
  • Re: Single ended signal over TL072 to a differential line
    ... martin griffith wrote: ... differential to single ended signals, ... ground with another 50 ohm resistor, this will look like a balanced ... fine-tune the amplification I think) but can go up to as much as 5 Volts ...
    (sci.electronics.design)
  • Re: Ethernet on fiber
    ... commercial converters. ... Marco / iw2nzm ... One method is to use a Wavelength division multiplexing, ...
    (sci.electronics.design)
  • Re: +5V from +35V
    ... Marco / iw2nzm ... Spehro beat me to it. ... recommendation as well. ...
    (sci.electronics.design)
  • Re: Reduce color saturation
    ... martin griffith wrote: ... Hmmm, since there is no luminance signal, just 3 color signals, it ... I've used generally used RGB to the Camera control units, ...
    (sci.electronics.design)