555 PWM circuit



Hi,

I've build a PWM control following this design:

http://www.pablin.com.ar/electron/circuito/varios/pwm-cc/index.htm

But I made some changes:

1. I don't know what the 10uF capacitor is used for, so I am not using
it.
2. As I want to use a high current motor (10A), I've changed:
2.1: IN5408 > BY229-600
2.2: IRF830 > BUZ11 with HEATSINK
3. I guess that the 1K resistor in the BUZ11 gate is used to discharge
the internal capacitor of the transistor (avoid over-heating), but if
I use it there is no current in the MOTOR
4. Capacitors on pin 6 and 5 are 10nF instead of 100 nF

I will use a 12v 10A motor, and a 12v 20Ah battery, but for testing
purposes I am using an standard battery car (12v 50Ah).

The circuit is working fine but I am experiencing some issues:

a) When the motor is not working at maximum I hear a high frequency
noise.
b) With the 50Ah battery I saw a 30A peak current, and the transistor
burned out. I am thinking about using a more powerfull transistor. Do
I need to change it or not? Cause I will use a 20Ah battery in the
final design.
c) I will use this PWM in a three-wheeled electric vehicle. What do
you think about the general project itself? It is enough with that
battery and motor? Any other advice?

Thanks in advance for your help.
Vicente.
.



Relevant Pages

  • Re: 555 PWM circuit
    ... I will try with that capacitor, but, do you know what is for? ... purposes I am using an standard battery car. ... See my note above about missing out components from a working design. ... You will just get less service time from the ...
    (sci.electronics.design)
  • Re: 555 PWM circuit
    ... I've build a PWM control following this design: ... I don't know what the 10uF capacitor is used for, ... I use it there is no current in the MOTOR ... purposes I am using an standard battery car. ...
    (sci.electronics.design)
  • Re: 555 PWM circuit
    ... I don't know what the 10uF capacitor is used for, ... I use it there is no current in the MOTOR ... purposes I am using an standard battery car. ... I will use this PWM in a three-wheeled electric vehicle. ...
    (sci.electronics.design)
  • Re: 555 PWM circuit
    ... I don't know what the 10uF capacitor is used for, ... I use it there is no current in the MOTOR ... purposes I am using an standard battery car. ... I will use this PWM in a three-wheeled electric vehicle. ...
    (sci.electronics.design)
  • Re: Need help in stablizing a power supply
    ... My guess is the motor ... >a large capacitor at the power supply output? ... The power source is from 12V lead acid battery. ... The high value capacitor you suggested, ...
    (sci.electronics.basics)