Re: 12 volt automotive fan speed controller

On Nov 25, 4:03 pm, Jim Thompson <To-Email-Use-The-Envelope-I...@My-
Web-Site.com> wrote:
On Sun, 25 Nov 2007 14:29:54 -0800 (PST), mel...@xxxxxxxxxxx wrote:
On Nov 25, 5:44 am, "mark krawczuk" <krawc...@xxxxxxxxxxx> wrote:
hi, sorry , i suppose i should have said, i just need a potentiometer to
control the speed , it doesnt need to be controlled by cabin heat
etc...., the fan controller in my car isnt working and they havea tendency
to fail , so i am trying to construct a bit more robust one . everything
is working fine the heat , aircon , its just that the factory controller
is broken and the fan always stays on really low,.

thanks,
mark k

[snip]

Most

CHEAP

auto heater blowers use wind cooled wire wound resistors in
series with the blower motor circuit to attain low and medium speeds
with high speed being a direct connection to 12+ volts. Some
regulatory body specifies that a super low speed is mandated to be on
all the time to guard against carbon monoxide poisoning, which is
probably the low speed you've noticed.

[snip]

The controller design I did for Bosch (Bühlertal, Germany) for
inclusion in the Mercedes AC/heat system was a 3-phase electronically
commutated motor... custom microchip plus 3 N-channel MOSFET's...
continuously variable speed, but controlled acceleration (so that the
chief engineer couldn't hear any whine when he stuck his head in the
air duct ;-)

...Jim Thompson
--
| James E.Thompson, P.E. | mens |
| Analog Innovations, Inc. | et |
| Analog/Mixed-Signal ASIC's and Discrete Systems | manus |
| Phoenix, Arizona Voice:(480)460-2350 | |
| E-mail Address at Website Fax:(480)460-2142 | Brass Rat |
| http://www.analog-innovations.com | 1962 |

America: Land of the Free, Because of the Brave

So where is your schematic?
.

Relevant Pages

  • Re: 12 volt automotive fan speed controller
    ... the fan controller in my car isnt working and they havea tendency ... series with the blower motor circuit to attain low and medium speeds ...
    (sci.electronics.design)
  • Re: USB stick access freezing up system?
    ... Or you could throw more money at it - use a better raid controller, add a large cache, and spread the data out over many spindles. ... Why isn't flash a good candidate? ... port 1 powered ... I don't have ny further suggestions - you should get good speeds from your memory sticks when they are connected to an ehci controller. ...
    (comp.unix.bsd.freebsd.misc)
  • Re: 12 volt automotive fan speed controller
    ... the fan controller in my car isnt working and they havea tendency ... series with the blower motor circuit to attain low and medium speeds ...
    (sci.electronics.design)
  • DIY: Lathe Control Pod (kinda off topic)
    ... adjust lathe speed and built this pod out of crap in the junk box. ... Works with any VFD-S series motor controller, ... speeds, and since the labels are Photochopped, they aren't necessarily ... The rotary switch is a ...
    (rec.crafts.woodturning)
  • Re: Stepper Motor Speed Problem
    ... > I am developing an stepper motor position control board in the ... >devicenet network.I want the motor to run in the microstepping (up to ... >controlling or else i should get the controller with some more higher ... looked at driver efficiency losses with switching speeds that high. ...
    (sci.electronics.design)