Re: PCB routing tips for PLCC packages
- From: Ben Jackson <ben@xxxxxxx>
- Date: Thu, 20 Dec 2007 12:49:12 -0600
On 2007-12-20, joseph <jozamm@xxxxxxxxx> wrote:
I am designing a circuit where i will be using an 84 pin through hole
PLCC package, with the pins in two concentric squares.
I'd just skip the socket and put the part down directly. PLCC is much
easier to deal with directly than in a socket. That's especially true
if you're going to etch the board yourself -- you can't solder any of
the pins to the top layer with a PLCC socket.
--
Ben Jackson AD7GD
<ben@xxxxxxx>
http://www.ben.com/
.
- References:
- PCB routing tips for PLCC packages
- From: joseph
- PCB routing tips for PLCC packages
- Prev by Date: Re: Yet another new battery breakthrough
- Next by Date: Re: How to quickly turn on/off N-FET switching high side of 55V?
- Previous by thread: Re: PCB routing tips for PLCC packages
- Next by thread: new york based electronics supply
- Index(es):
Relevant Pages
|
