Re: If you're good at breadboarding & simulations, please, join the discussion!
- From: The Flavored Coffee Guy <elgersmad@xxxxxxxx>
- Date: Sat, 16 Feb 2008 00:42:25 -0800 (PST)
That's funny, negative resistance works out like a self biased
transistor in a box with a wire running through it. As you increase
the voltage across the circuit, current increases disproportionately.
If you start with 100 ohms of resistance at 1 volt, negative
resistance results in 50 ohms at 2 volts.
The conductivity of a plasma is dependant on two factors, the desity
of the gas or pressure, and temperature.
http://ocw.mit.edu/NR/rdonlyres/Nuclear-Engineering/22-616Fall2003/CCFA04BC-4956-4679-A050-3D82EEB749F6/0/collisionstrans2.pdf
Or you can go here and ask yourself why is this arc so much longer
than any distance between two wires?
http://www.youtube.com/watch?v=PXiOQCRiSp0
The answer is simple, plasma is more conductive than wire. The amount
force generated by heat shows you how much longer the plasma channel
must be before a list of factors finally allow it to break. If that
were a magnetically coupled plasma in a penning trap the gas couldn't
rise and the potential of heat causing to would be eliminated. So,
500KV can go that far, and be that hot.
.
- Follow-Ups:
- References:
- If you're good at breadboarding & simulations, please, join the discussion!
- From: The Flavored Coffee Guy
- Re: If you're good at breadboarding & simulations, please, join the discussion!
- From: mng
- Re: If you're good at breadboarding & simulations, please, join the discussion!
- From: The Flavored Coffee Guy
- Re: If you're good at breadboarding & simulations, please, join the discussion!
- From: John Larkin
- Re: If you're good at breadboarding & simulations, please, join the discussion!
- From: Rich Grise
- Re: If you're good at breadboarding & simulations, please, join the discussion!
- From: krw
- Re: If you're good at breadboarding & simulations, please, join the discussion!
- From: Rich Grise
- Re: If you're good at breadboarding & simulations, please, join the discussion!
- From: krw
- If you're good at breadboarding & simulations, please, join the discussion!
- Prev by Date: Re: Sample and Hold Circuts
- Next by Date: Re: If you're good at breadboarding & simulations, please, join the discussion!
- Previous by thread: Re: If you're good at breadboarding & simulations, please, join the discussion!
- Next by thread: Re: If you're good at breadboarding & simulations, please, join the discussion!
- Index(es):
Relevant Pages
|
Loading