DAC with variable sample rate

Hello!

Is it possible to control the sample rate of a DAC (no oversampling,
of course) with an analog VCO, variable within a wide range (few Hz up
to 10Mhz), also frequency-modulated?
First without consideration how to feed it properly.

Regards,
Oliver
.

Relevant Pages

  • Re: DAC with variable sample rate
    ... Is it possible to control the sample rate of a DAC (no oversampling, ... of course) with an analog VCO, variable within a wide range (few Hz up ... To vary the data rate, that's up to the other electronics not the DAC. ...
    (sci.electronics.design)
  • Re: Resample MHz signal
    ... PC and then play it back at 100 times the original sample rate. ... Basically what you are after is a DAC that can go up to several MHz. ... On DOS machines that aren't laptops, the 18.2Hz interrupt can be taken ...
    (sci.electronics.design)
  • Re: Is higher oversampling ratio better in signal fidelity in digital world?
    ... as you lower the sample rate you increase the ... digitization (Your sampled sine wave will start to look like a square ... Clocking that data through a DAC at the same rate will produce ... if the playback rate is too slow. ...
    (comp.dsp)
  • Re: Examples of Anti-Anti-Alias Requirements
    ... the oversampling makes it easier to skimp on or dispense with an anti-alias filter. ... The typical oversampling delta-sigma ADC creates a delay as long as 10...20 periods of the output sample rate. ... To provide for the sufficient loop gain and stability, the sample rate has to be at least at the order higher then the highest frq. ...
    (comp.dsp)
  • Re: Is higher oversampling ratio better in signal fidelity in digital world?
    ... as you lower the sample rate you increase the ... digitization (Your sampled sine wave will start to look like a square wave). ... Clocking that data through a DAC at the same rate will produce strong ...
    (comp.dsp)