11V to 15V AC/DC switching power supply?

how would i get started designing an 11V to 15V DC output, AC/DC (wall
power) switching power supply? so with a pot I can adjust the output
voltage. output current is about 1.5A. drives a motor.

any ideas on how i can get started with this? where to look for
circuit possibilities?


.

Relevant Pages

  • Re: K4600 Screen Is All Green
    ... Since I don't know what a rejuvinator is, I'm guessing I don't have one:) I'm a bit green when it comes to repairing monitors since this is the first time I have really had to do something other than adjust a few settings. ... You can also remove the monitor and rotate it to see if it doesn't go green again. ... I will admit the the pot did feel a bit loose, although I am still baffled by why it only starts blasting green after 5-10 seconds. ... A tube shooter would be your best bet right now.. ...
    (rec.games.video.arcade.collecting)
  • Re: EBD - need HV help, part(s)
    ... adjust pot and the resistance of the pot itself measures ok on my ... in that 'adjust' section have gone south. ... as I turned the pot I could see the display tubes glow going up ... Also could the HV being at 220 for a few hours today cause one digit ...
    (rec.games.pinball)
  • EBD - need HV help, part(s)
    ... adjust pot and the resistance of the pot itself measures ok on my ... in that 'adjust' section have gone south. ... as I turned the pot I could see the display tubes glow going up ... Also could the HV being at 220 for a few hours today cause one digit ...
    (rec.games.pinball)
  • Re: treble bypass capacitor question
    ... I went to Carvin's site, and all I found on pot values, was the ... and I've put treble bypass caps in a bunch of guitars. ... have a series resistor and another parallel resistor across the whole ... I doesn't persist after I adjust the volume, ...
    (alt.guitar)
  • Re: out of plumb wall
    ... and adjust the width to compensate or the wall, ... I'm assuming from the age the door casing/frames are built up of stock not prehung units. ... At that point I'd look at rehanging the door and compensate as needed. ...
    (alt.home.repair)