Re: Problem with PIC & LCD display
- From: allanhvii@xxxxxxxxx
- Date: Fri, 2 May 2008 14:24:18 -0700 (PDT)
On May 1, 12:51 pm, Steve H <ste...@xxxxxxxxxxxxxxxx> wrote:
I'm having a problem with a fairly simple project incorporating a
16F877A PIC and a 4x20 alphanumeric display module. The circuit
interfaces with other logic ICs, though these can be removed from the
circuit to isolate the problem.
The circuit is fed, under test conditions, from a linear 12v power
supply. The 5v regulator on the circuit board is decoupled using 100nf
ceramic capacitors. There is similar decoupling on the PIC itself, and
at other places e.g. decoupling the 5v supply on the connector to the
LCD display. I have also fitted a 100uH coil in the supply to the 5v
regulator to reduce any effects from spurious noise on the supply line.
The problem I'm having difficulty solving is that the display will
intermittently go blank. It will go blank, seemingly when the display is
written to by the PIC, either (a) due to a spike/noise on the mains
supply (this can be intermittently reproduced by repeatedly turning on
and off a piece of mains powered equipment on the same circuit), or (b)
when the 0v rail (not even necessarily close to the LCD display) is
touched by for example a multimeter probe. This is the most consistent
way of producing the fault. The multimeter can be turned off and the
other probe not connected to anything for this to happen. The PIC
doesn't appear to be affected by any of this as it can be shown to still
be operating as expected.
I've experienced similar issues before in my limited experience of
building small projects with PICs. I had issues with a 16F84A resetting
itself when the 0v rail close to the IC was touched with a screwdriver.
Can anybody suggest what vital consideration for circuit design I'm
missing. I'm at a bit of a loss as to what I'm doing wrong.
Thanks.
--
Steve H
I'm having the same type of problem with a new design using a 2 line x
16 Optrex display with an Atmel Arm 7 micro in the 4-bit mode. I tried
swapping to a Hantronix display with little or no improvement.
If I create a high voltage arc near (within an inch or so) the LCD
(without even touching the board), the display goes into a lockup
state. I've changed the software to attempt a software reset of the
LCD, but nothing seems to shake it loose except a power cycle. (The
LCD has no reset line.) Also, the processor is still running,
evidenced by the debug data it pumps out as well as a few other
indicators. The LCD unit is mounted 1/4 " from the main PC board using
standoffs and a connector; there is no ribbon cable.
I generate the arc using a lighter (without the tank), which is a
piezo electric spark. (A long handled grill lighter.) I started this
because the board had difficulty in conformance testing with the ESD
test.
Have you made any progress on your problem? Maybe we can share our
results.
.
- Follow-Ups:
- Re: Problem with PIC & LCD display
- From: cbarn24050
- Re: Problem with PIC & LCD display
- From: allanhvii
- Re: Problem with PIC & LCD display
- References:
- Problem with PIC & LCD display
- From: Steve H
- Problem with PIC & LCD display
- Prev by Date: Re: OT: Global Warming
- Next by Date: Re: OT - Something actually worked!
- Previous by thread: Re: Problem with PIC & LCD display
- Next by thread: Re: Problem with PIC & LCD display
- Index(es):
Relevant Pages
|
