Re: 0.1 Volts output voltage regulator

On Wed, 14 May 2008 11:24:37 -0700, David Gravereaux
<davygrvy@xxxxxxxxx> wrote:

David Gravereaux wrote:
john wrote:
Hi,

I am looking for a +/- 0.1 volts output voltage regulator. I have
+/- 5 volts input. Any advice!

Thanks
John

LM317

Wait a sec.. I think I was too quick. It doesn't fully pinch off now
that I think about it.

It will regulate down to (or below!) zero volts if you set the adjust
pin right. Ditto LM337.

The op left a lot unspecified, as usual.

John


.

Relevant Pages

  • Re: LEAD ACID BATTERY
    ... My circuit draw is 700mA and requires plus minus 18 volts to ... I need batteries that can atleast run for 10 to 12 ... Can anybody advice me that am I doing the right thing that will these ... Have you considered one 12V battery, and a DC-DC converter to generate ...
    (sci.electronics.design)
  • computer power supply battery charger
    ... advice talks about putting a load resister from 12v to ground to turn on ... power resister in series gives 3 volts ... using ohms law i get .600 amps--am i right so far? ...
    (sci.electronics.misc)
  • Re: 0.1 Volts output voltage regulator
    ... I am looking for a +/- 0.1 volts output voltage regulator. ... +/- 5 volts input. ... Any advice! ...
    (sci.electronics.design)
  • Re: TECH: Data East wont boot
    ... Did step by step on Marvins repair guide and got to where ... the vma line has higher than 2-3 volts. ... trying to learn just as a hobby so any advice would be great. ...
    (rec.games.pinball)
  • Re: BC-453 H.V.
    ... output was 250 volts at .05 amps with 28 volts input. ... DM-32 could be used for powering it, as it had 12 volts input and the same ... volt heater winding instead of 6.3, along with 5 volts for a rectifier ...
    (rec.radio.amateur.boatanchors)