Re: a lot of switching mode power supply design questions



On May 31, 3:22 pm, legg <l...@xxxxxxxxxxxxxxx> wrote:
On Sat, 31 May 2008 09:39:43 -0700 (PDT), MooseFET

<kensm...@xxxxxxxxx> wrote:
On May 29, 7:06 pm, bigca...@xxxxxxxxx wrote:
I modified it and deleted the C-L on the right side.

Did you understand what those two parts did?

They allowed you to have zero ripple current in the LED.

You might want to recheck this circuit, boss. Your capacitors are in
Farads, and your inductors are in Henries. You won't see much
happening in the simulator's 100mSec time frame.

I just checked:
C1 = C2 = 100uF

L1 = 12.2uH

L2 = 10uH

K1 = 0.9


RL

.



Relevant Pages

  • Re: Simple but Fundamental Antenna Question
    ... >> circuits as consisting of lumped components (resistors, capacitors, ... A whip antenna may be visualized from ... >> circuits) as a long chain of little inductors with small capacitors ... >> available to soak up magnetic and electric fields from the next part ...
    (sci.electronics.basics)
  • Re: My capacity to react
    ... but in reality all capacitors & inductors have some ... That resistance will offset the phase shift slightly. ... It is important to note that the losses in an inductor are not limited ...
    (alt.guitar.beginner)
  • Re: ESD protection as easy as a cheap LC filter?
    ... >> inductor is momentarily an open circuit, ... > series and serious attention needs paying to the damping components. ... One thing to remember is that most inductors start looking like ... capacitors at sufficiently frequencies, while most capacitors start ...
    (sci.electronics.design)
  • Re: Nationalized Health Care Preview?
    ... inductors and capacitors in Excel, ... destructive interference to constructive interference. ... lots of big inductors in series. ... Any time-symmetrical waveform will only contain even harmonics. ...
    (rec.arts.sf.fandom)
  • Re: Paralleling caps to meet ripple current requirements?
    ... The cap between inductors would normally see ... final cap, you have to deal with where that current goes. ... to get the most use from those capacitors and minimize ... magnetic fields caused by the ripple. ...
    (sci.electronics.basics)