Re: OT Coleman PowerMate PROBLEM FOUND
- From: Jim Yanik <jyanik@xxxxxxxxx>
- Date: 11 Jun 2008 14:45:25 GMT
"amdx" <amdx@xxxxxxxxxxx> wrote in
news:b557a$484fc081$18d6b40c$27712@xxxxxxxxxxx:
>Coleman powermate generator quit working 1 hr 15 min after
>>working
properly. (Pro-Gen 5000)
A few minutes ago I pulled the cover and found a 19 turn coil in the
stator burned (overheated, no insulation left on copper). The unit
has a pcb with 8 diodes and a capacitor, a foil on the pcb has
overheated and opened. The foil goes to a 470uf 200v capacitor. The
only connection to that part of the open foil is the capacitor.
Leading me to think the cap is shorted, but at this time and
temperature, the cap shows very high resistance (over 2 meg) and
deflects the meter both ways if I charge the cap and reverse the
leads. ( deflects? I'm using a digital meter, but you know what I
mean). The diodes all check good.
I don't know if I'll attempt repair at this point. It looks like the
19
turn coil could be replaced fairly easy, it's pretty loose in the
slot. The motor was not dipped in varnish.
Later, Mike
GREAT!
I'd use my ESR meter on the cap to check it.
Can you -rewind- that 19T coil with new wire?
--
Jim Yanik
jyanik
at
kua.net
.
- Follow-Ups:
- Re: OT Coleman PowerMate PROBLEM FOUND
- From: amdx
- Re: OT Coleman PowerMate PROBLEM FOUND
- References:
- OT Coleman PowerMate Generator
- From: amdx
- Re: OT Coleman PowerMate Generator
- From: GregS
- Re: OT Coleman PowerMate Generator
- From: amdx
- Re: OT Coleman PowerMate Generator
- From: Jim Yanik
- Re: OT Coleman PowerMate Generator
- From: amdx
- Re: OT Coleman PowerMate PROBLEM FOUND
- From: amdx
- OT Coleman PowerMate Generator
- Prev by Date: Re: OT Coleman PowerMate Generator
- Next by Date: Re: OT Coleman PowerMate PROBLEM FOUND
- Previous by thread: Re: OT Coleman PowerMate PROBLEM FOUND
- Next by thread: Re: OT Coleman PowerMate PROBLEM FOUND
- Index(es):
Relevant Pages
|