Re: switch selection

On Jun 20, 9:15 am, John Fields <jfie...@xxxxxxxxxxxxxxxxxxxxx> wrote:
On Fri, 20 Jun 2008 05:57:57 -0700 (PDT), Michael <mk5...@xxxxxxxxx>
wrote:

I just checked "mechanicals". The height limits are: <5mm one side of
PCB and <2mm another side of PCB. Ooooops!
:o(

---
Check this out:

http://www.hamlin.com/specsheets/MARR-5.pdf

You'll need to get/wind a coil for it, but at 17AT you should have no
problem fitting it onto the 5mm side of the board.

What supply voltage do you have available to drive the coil?

And, BTW, can you rout a slot in the board and slip the relay into it
to get a few more mm of height that way?

JF

One more comment. If I have zero cutout tolerance, I will have 0.5mm
of leads on each side to solder to. The relay has 0.2mm width
tolerance. This leaves me with 0.3mm. The leads have +...-0.3mm
tolerance. This leaves me with... nothing.
:o(
.

Quantcast