Re: 12V regulator

On Sun, 19 Oct 2008 21:35:39 -0400, legg <legg@xxxxxxxxxxxxxxx> wrote:

On Sun, 19 Oct 2008 13:19:11 -0500, Steve <s@xxx> wrote:

I have a spst lighted switch that uses a 12vdc lamp (led w/ resistor).
It's just a basic three terminal switch, one is n.o., one is common,
the other is +12vdc for the lamp. I'm trying to design a circuit
that's a basic as possible to drop the 115vac down to 12v.

A .047uF 400Vdc or 250Vac (X2) will limit led current to ~2mA,
approximately half of which goes through the led. Placing a 100R 1/2W
resistor in series will limit capacitive surge current through the
diode required to route reverse polarity current around the indicator
terminals.

Due to switch construction, the whole shebang will be live when the
switch is on, so suitable precautions are required to isolate this
from surrounding circuitry and hardware and to fix the parts securely
in position.

Brightness may be an issue - larger capacitors, at this voltage, tend
to get physically large.

This is probably only cheaper than obtaining the appropriate switch if
all of the parts required are already on hand.

RL
I think you're right, probably best to just go get a neon switch. I
was trying to use parts I had on hand, this was a nice looking blue
led switch, but it's proving a bit more difficult than I wanted for
this particular application. Thanks for the replies,
Steve
.

Relevant Pages

  • Re: Momentary Switch Circuit
    ... >He's replacing a momentary switch. ... Since whatever circuit he's driving will work ... It should deliver close to Vcc. ... but primarily on the zener. ...
    (sci.electronics.design)
  • Re: Momentary Switch Circuit
    ... >>He's replacing a momentary switch. ... Since whatever circuit he's driving will work ... but primarily on the zener. ... >>It will be a spike, but it should be a spike whose ...
    (sci.electronics.design)
  • Re: The RCS: Voice Transcript
    ... Have you gone through the circuit analysis for the circuit that ... sustained power to the heater is what did it. ... That thermo switch ... It is now known, however, that the tank contained two protective ...
    (sci.space.history)
  • Re: HELP With Step-Down Transformer and Converter
    ... battery, this is not needed because a transformer is not needed. ... You need a disconnect so that all you have to do is flip the switch and everything ... The disconnect should be the first thing in the circuit connected to one ... You should turn off the breaker or switch while making ...
    (sci.electronics.design)
  • Re: Help needed for simple circuit troubleshoot
    ... >> circuit shown in the following diag. ... >> once the switch is turned on, but when the switch is turned off it takes ... The voltage drops to 5v on the emitter leg of the MOSFET. ... > it'll hold the load at between 2 and 4 volts below the battery voltage. ...
    (sci.electronics.basics)