Re: TTL signal



On Dec 9, 3:14 pm, Phil Hobbs <pcdhSpamMeSensel...@xxxxxxxxxxxxxxxxxx>
wrote:
jamie_krie...@xxxxxxxxx wrote:
I'm trying to convert an analog signal, 150mV, 3-5nS pulse width to a
TTL signal.

What sort of TTL are you going to use with a 3 ns pulse????

Cheers,

Phil Hobbs

I'm looking to use the TTL as a trigger pulse for an NI scope
application. So the pulse can be stretched longer than the 3nS pulse.
The 3-5nS pulse is coming from a photodiode circuit on a Cobolt Tango
Laser.
.



Relevant Pages

  • Re: Flag desecration?
    ... Vcc - Vth ... k for Vih = 2.0V will be: ... We were simulating a circuit where the restor was tied to the TTL ... pulse, "OUT", and the timing will look something like this: ...
    (sci.electronics.design)
  • Re: TTL signal
    ... What sort of TTL are you going to use with a 3 ns pulse???? ... So the pulse can be stretched longer than the 3nS pulse. ... could you set up your FTP server to accept PASV? ...
    (sci.electronics.design)
  • Re: TTL signal
    ... John Larkin wrote: ... What sort of TTL are you going to use with a 3 ns pulse???? ... Phil Hobbs ... So the pulse can be stretched longer than the 3nS pulse. ...
    (sci.electronics.design)
  • Re: TTL signal
    ... What sort of TTL are you going to use with a 3 ns pulse???? ... So the pulse can be stretched longer than the 3nS pulse. ... Perhaps you should start over again and tell the _whole_ story: "I am trying to trigger a NI scope board with a Cobolt Tango laser which has a photodiode output. ... "Applied Control Theory for Embedded Systems" gives you just what it says. ...
    (sci.electronics.design)
  • Re: TTL signal
    ... What sort of TTL are you going to use with a 3 ns pulse???? ... So the pulse can be stretched longer than the 3nS pulse. ... I assume the scope has an analog trigger input, ...
    (sci.electronics.design)