Bi-directional audio over power cable

Hi,

I'd like to add an intercom functionality to a broadcast camera and I'd appreciate opinions about the different solutions I have in mind.
The main restrictions come from the cable, which is a big shielded cable with optical fiber inside, a pair of 37.5Ohm/km for power (300V DC), and a pair of conductors for RS-485 control signals. The cable can be up to 1km long.

The first option is to add analog audio on top of the DC power but I see 2 problems here:
- the power cables are not individually shielded so I'll get noise from the RS-485 signals, I've no idea how bad that can be and if that can still be OK for voice;
- as I need bi-directional audio, I guess I have to shift the audio signals to higher frequencies to have both on the same line.

Second option would be to use the RS-485. It's currently at 9.6kbps but I've read that bitrates can be up to 100kbps for 1km lines. At that bitrate I should be able to use speech codecs with half-duplex transmission. Would the transmission still be reliable at 100kbps?

Third option is to use the optical fiber and stream UDP audio. Here it sounds like a more complex architecture to design, but maybe I could find commercial modules that handle that already so it might be the easiest option in the end.

Any thoughts?

Thanks,
David Bourgeois
.

Relevant Pages

  • Re: Cutting Coaxial Cable
    ... Do I have to call my cable tv company to tell them to turn off power to ... NO, these cables carry RF, no dangerous voltages/currents. ... if you have to ask if you'll get electrocuted cutting a CATV ... regulations on signal leakage from CATV systems since the signals on the ...
    (alt.home.repair)
  • Re: Bi-directional audio over power cable
    ... I'd like to add an intercom functionality to a broadcast camera and I'd ... pair of conductors for RS-485 control signals. ... The first option is to add analog audio on top of the DC power but I see 2 ... the power cables are not individually shielded so I'll get noise from ...
    (sci.electronics.design)
  • Re: Shielded mains cable
    ... would be needed to make the range of DSL on a given cable ... Trans-oceanic telephones cables used very high voltages. ... were powered in series like Christmas tree lights, ... range of DSL less than range of voice signals, ...
    (rec.audio.tubes)
  • Re: Bi-directional audio over power cable
    ... I'd like to add an intercom functionality to a broadcast camera and I'd ... pair of conductors for RS-485 control signals. ... The first option is to add analog audio on top of the DC power but I see 2 ... the power cables are not individually shielded so I'll get noise from ...
    (sci.electronics.design)
  • Re: Bi-directional audio over power cable
    ... The main restrictions come from the cable, which is a big shielded cable with optical fiber inside, a pair of 37.5Ohm/km for power, and a pair of conductors for RS-485 control signals. ... the power cables are not individually shielded so I'll get noise from the RS-485 signals, I've no idea how bad that can be and if that can still be OK for voice; ... as I need bi-directional audio, I guess I have to shift the audio signals to higher frequencies to have both on the same line. ...
    (sci.electronics.design)
Quantcast