combatting line droop in catanery designs


There's a long thread in m.t.r.a about the catenary network used on
Amtrak's NE Corridor and elsewhere. [See the ref's if you want to start
at the beginning..]

For historic [i.e. even older than Jim!] reasons, it's 11KV@25 Hz. over
much of the distance. Amtrak is awaiting money to make it all 25KV@60Hz,
and expects to do so about the time cold fusion power plants come on
line in Fedwick. Until then....

But someone points out it is really 50KV center-tapped. One leg is the
cat itself; the other a feeder in parallel. Periodically, a center-tapped
autotransformer mounted track-side goes feeder-rails-cat. Railroad folks
call this 2x25KV, I gather.

See a similar spec:
<http://indianrailways.gov.in/financecode/ACTraction-II-P-I/ACTractionIIPartICh11_data.htm>


The claimed advantages are:

a) less droop under load, no small matter when an Acela draws about 10 MW.

b) EMI cancellation since the feeder and parallel cat are out of phase.

c) You can tap up on the auto-formers further from a feed.

On a) I'm trying to model in my head why it is better than just
paralleling the feeder with the cat every few 100 meters. I can't see an
advantage.

b) I'm dubious on but will let go.

c) bothers me; if T{mile 0} is tapped at 25 0 25 [feeder rail cat], and T{mile2} is tapped so as to
provide more voltage there [25 0 26]; what happens at no load? I think the two transformers will
fight it out, heating the 2 miles of cat resistance and driving up the bill.

Insight welcome...


ps: Which Jim is the question...
.

Relevant Pages

  • Re: combatting line droop in catanery designs
    ... EMI cancellation since the feeder and parallel cat are out of phase. ... the periodic lineside transformers act as common-mode ...
    (sci.electronics.design)
  • Re: more about hummers
    ... have one female who has reached the "feathered ping-pong ball" stage. ... she had a hard time figuring out the feeder. ... And while I was typing that I looked out to see that the young gray cat ... I guess the bird decided the cat was not good to eat and flew off. ...
    (rec.birds)
  • Re: [OT] Wild birds, was Re: fitting help (mans shirt)
    ... Back before I started keeping the cats in the house all the ... I left the cat doors open so they could come and go. ... feeder ... was empty, the water dish looked like mud, and there was this ...
    (alt.sewing)
  • Making hummingbird feeders cat-"proof"
    ... Some years ago the neighborhood cat was killing the hummingbirds at my ... prickly pear under the feeder. ... plenty of other thorny plants, ...
    (rec.birds)
  • Re: disconnect box when adding subpanel
    ... add a disconnect breaker near the new subpanel...but...I can not find ... anything rated at 125 amps at either Home Deport or Lowes. ... No one will make you use a 125 ampere feeder merely because your panel can carry that load. ...
    (alt.home.repair)