Pin out of the Programming jumpers on the Kenwood PD35

Hi

Could someone be so kind and let me know what the pinout of the jumpers
are on the back of the Kenwood PD35 PSU.
All the jumpers have been removed and thus I can not get it working.

Thanks

WayneL

PS if you could would you scan in the page in the manual and send it to
me at home@xxxxxxxxxxxxxxxxxxxx (remove nospam-)

.

Relevant Pages

  • Re: 64C PAL J3 connection
    ... Time to dig out the solder and jumpers. ... Prev by Date: ...
    (comp.sys.cbm)
  • microlive
    ... relive those memories of Ian Mcnaught-davis, fred harris's jumpers and ... Lesley judd! ... check out uknova.com - about 20 odd episodes! ... Prev by Date: ...
    (comp.sys.sinclair)
  • Re: Why does a change in jumper length change amplifer outout?
    ... > transistors in common emitter mode. ... What type of cable and connectors are the two jumpers? ... Prev by Date: ...
    (rec.radio.amateur.homebrew)
  • Re: Sound problems on A8N-SLI
    ... have needed to because those jumpers should have been factory ... Ron ... Prev by Date: ...
    (alt.comp.periphs.mainboard.asus)
  • Re: Clearing open firmware password
    ... > It also mentions that you can bypass the password "Via physical ... I don't see any jumpers that ... Charles ... Prev by Date: ...
    (comp.sys.mac.hardware.misc)