Sencore SC3100 & HA2500 owners, a little help please

So I bought a Sencore SC3100 scope on ebay and it didn't come with a
probe. I admit I got caught up with a little auction frenzy and should
have checked into the probe thing first. Do you need a special probe
for these things? Or can you use any scope probe? If any of you know
this could you let me know. Sencore sells them for $158.00 on their
ebay store but I hope I don't have to spend that much on one. Also...

HA2500 owners. Same thing. There are two probes once is just with a
small plug that ends in three clips and one ends in two clips. They
want $68.00 for the three wire one. That is a little bit too much for
three leads and a plug. If someone who owns one of these could you
tell me what the color goes to what pin on the plugs. I will just make
my own.

I really apprecate any and all help.
Thanks
Russ
StateStreetAmusements@xxxxxxxxxxx

.

Relevant Pages

  • Re: Tek 465 oscope - no display
    ... EBAY crap? ... Before I did anything with the scope, I read the manual and set ... so I jumped to the probe compensation section so I ... I set the V/div and time scale nearest to ...
    (sci.electronics.repair)
  • Re: more scope questions
    ... This is not to say the scope is working. ... Each channel to AC and v/cm to 1. ... You should be able to move trace up and down screen using position ... I don't know if the probe is actually OK. ...
    (alt.guitar.amps)
  • Re: Learning Mosfets...RdsON Warm Up?
    ... Is the mosfet material is heating up and becoming more resistive? ... A 12ohm resistor from drain to V+ = 15V. ... Scope 10:1 probe on drain. ... Try adjusting the little screw on the probe. ...
    (sci.electronics.design)
  • Re: Allowable voltages on Scope
    ... measuring procedures. ... Placing a probe tip near a transformer or inductor will often provide ... adequate signals for the scope to display. ... an isolation transformer is utilized to troubleshoot/test ...
    (rec.crafts.metalworking)
  • Re: Allowable voltages on Scope
    ... Placing a probe tip near a transformer or inductor will often provide ... adequate signals for the scope to display. ... an isolation transformer is utilized to troubleshoot/test ...
    (rec.crafts.metalworking)