measurements corp model 80 sig gen



The am modulation in my model 80 quit. Which tubes are used in this circuit? The rf output is OK.

tnx, AL

.



Relevant Pages

  • Re: More cap tuning
    ... The two tubes are amplifying the same ... flow, while idle, allows perfect silence to be output to the speaker, ... pass signals. ... I learned of this circuit from John Broskie's www.tubecad.com site. ...
    (rec.audio.tubes)
  • Combination class A/AB Switch and post-PI Master Volume circuit idea - comments?
    ... I show a typical connection of phase inverter to output stage, ... using a stereo pot to cut both phases equally, or using a pot wired as ... I've tried the rheostat circuit, ... I'm putting tubes into an old solid-state Univox combo that sounds ...
    (alt.guitar.amps)
  • Re: stereo amp cleaning
    ... Any protection circuit is there ... simply to protect the speakers from an amp failure, ... I was going to mention tubes but I'd already gone on too long... ...
    (sci.electronics.repair)
  • Re: 211 and 845 operating Ea/Ia bias points.
    ... Anthony's suggestion (different tubes, different values, different ... I'd be interested to hear more details on the silicon pseudo choke. ... I'm sure you know how to make a CCS but if you, or anyone else, don't ... A great circuit component if you're more interested in music ...
    (rec.audio.tubes)
  • Re: rating of 15.6 ohm bias resistor in ST-70
    ... Scroll down to Blumlein auto bias. ... Blumlein came up with an auto-bias matching circuit that ... mismatched set of output tubes by using two tubes in parallel, ... The single common cathode resistor is the winner; ...
    (rec.audio.tubes)

Loading