Re: Defective Power supply in HP8711a Network Analyser.

Does this can help?

http://cp.literature.agilent.com/litweb/pdf/08711-90108.pdf

73's
pf


"Rivendel_Ivo" <rivendel@xxxxxxx> a écrit dans le message de news:
2d9e4326-37e2-4ae3-b39e-dcc3b290a3b2@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Around 10 years ago I bought a (second hand) HP8711a and it worked
fine.
Since we moved to another house (few months no power on the unit) now
and then the instrument stops working (power down). Now it is so bad
that the unit does not even boot anymore......

Pulling RF units from the instrument does not help; problem remains.
(I once had a RF unit with a shortened Tantalium capacitor).

I am looking for the schematics of this unit (HP number 08711-90004)
but no one can help me with this.
Is there anyone who can give me a hint were to get these schematics or
does anyone have similar problems?

Ivo Maatman Borne Netherlands.


.

Relevant Pages

  • Defective Power supply in HP8711a Network Analyser.
    ... Since we moved to another house (few months no power on the unit) now ... and then the instrument stops working. ... I am looking for the schematics of this unit ...
    (sci.electronics.equipment)
  • Re: Yet unadressed topic : cathode follower before the tone stack
    ... not to its full extent though and it's a pain in the ass to transfer the schematics to the program. ... From my previous experience of building a tube power amp, I stuck to the schematics and it works perfectly so I think that sticking to the schematics will give something at the very least workable. ...
    (alt.guitar.amps)
  • Re: Yet unadressed topic : cathode follower before the tone stack
    ... to transfer the schematics to the program. ... From my previous experience of building a tube power amp, ... I took a 4*6L6GC power amp section and simply put 2*EL84 instead ...
    (alt.guitar.amps)
  • Re: Silly resistor values
    ... Power supplies normally get connected on globals. ... Power supplies make a mess of schematics and add little ... have multiple blocks because there are dozens of channels but delay ... hardware engineers, three firmware types, a layout engineer, ...
    (sci.electronics.design)
  • Re: Yet unadressed topic : cathode follower before the tone stack
    ... to transfer the schematics to the program. ... I took a 4*6L6GC power amp section and simply put 2*EL84 instead ... Yeah yeah, I know, PCB has a bad reputation for tube amps but once again, my ...
    (alt.guitar.amps)
Loading