Re: alternator circuit question

From: Sam Steele (someone_at_nowhere.com)
Date: 11/19/04 

Date: Fri, 19 Nov 2004 07:48:16 GMT

Blue supplies ignition switched battery voltage to the field circuit and the
green wire is the one used by the computer to ground and field the circuit.
You can splice in an external voltage regulator, being sure to ground it
against wherever you decide to mount it.
"maxpower" <gjbeasley@comcast.net> wrote in message
news:p4udnTKlpLgm3wDcRVn-qQ@comcast.com...
> the regulator is internal to the PCM, not external. been awhile since i
> worked on this vehicle so i cant tell you the circuit numbers,
> but......you
> have the 2 field wires, i believe they are both green wires...... with the
> key on, car not running you should have battery voltage to one of those
> wires, remember which one it is, now start the car, the other wire is
> going
> to the PCM, if you ground that wire it will full field the alterator, that
> will tell you if the alt is putting out... if it does start charging when
> you do that..trace that wire back to the PCM and make sure it is a
> completed
> circuit, assuming it is and the alt is not charging, replace the pcm,
> thats
> a 100amp alt. i would not tamper or modify it in any way
> Glenn Beasley
> Chrysler Tech
> "Jon G." <jon8338@peoplepc.com> wrote in message
> news:bTand.3200$Qh3.682@newsread3.news.atl.earthlink.net...
>> I have a 91 Plymouth Acclaim, and the alternator doesn't charge
>> the battery. I took the alternator out and had it tested, and
>> there's nothing wrong with it. I put a new battery in it, but
>> it still won't charge. I checked the fuseable link from the
>> alternator to the battery, and there is continuity. Therefore,
>> it must be the computer.
>>
>> there are 4 connections on the alternator
>>
>> L1: direct to battery, positive
>> L2: direct to battery, negative
>> c1: small wire, logic, to computer, activates diode
>> c2: small wire, logic, to computer, also battery ground.
>>
>> I want to activate the alternator continuously and put on an
>> external voltage regulator.
>>
>> What must the voltage (and current), to the logic inputs c1 & c2
>> be to do so?
>>
>> I have in mind to run a potentiometer between L1 and c1, and
>> adjust it until the alternator kicks on.
>>
>> The schematic shows that c1 goes to the coil of a transformer in
>> the alternator, which then goes to one of the diodes (an SCR?)
>
>