Re: 12 volt peg perego

On 2005-10-21, johnswan <swanboats@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx> wrote:

> I have an older model 12 volt peg perego which runs on 2 -6volt
> batteries.

peg perego seems to be a brand name, I'm guessing this is mose sort of
child-sized electric vehicle

> The nine wires are disconnected and I have no idea how to
> put them into the two switches to make it run again. One switch has 6
> prongs the other has 3 prongs.
> The wires colors from one battery is
> white/red and white/black with a brown wire attached.
> the other battery wires colors are a solid blue and a solid yellow.
> The wires coming from the vehicle are, Brown (attached to the
> white/black of the battery) Red, Black and Green. There is the
> battery charger switch which has smaller gauged wires which there are
> 2 wires yellow and gray.
> Does anyone have any idea how to put it back into working condition?
> I would be ever grateful for any help. Thank you!


the 6 prong switch is almost certainly for forwards/reverse
the three prong could be a speed controller or could be to
switch from charging to riding mode.

expect something like this:


<--------.
to charger | / speed controller
<------. | /
| | ...... forwards/reverse switch
.-)-+--o o-----. /
___/ | : : | /
| +| | ..o... | /
|6v | | | .--o o o---.
| -| | | | ~~~~ |
~~~\ | | | ____ |
___/ | | | o o o-. |
| +| | | | | | | |
|6v | | | | `--)----)-+---->
| -| | | | | | to motor
~~~\ | | `-----)----+------>
\ | | |
`+------+--------'

or if the motor has 4 wires, like this

<--------. speed controller
to charger | ......
<------. +--o o------------>
| | : : to motor field windings
.-)-' :.o..: o------>
___/ | | |
| +| | | |
|6v | | | .--o o o---.
| -| | | | ~~~~ |
~~~\ | | | ____ | forwards reverse switch
___/ | | | o o o-. |
| +| | | | | | | |
|6v | | | | `--)----)-+---->
| -| | | | | | to motor brushes
~~~\ | | `-----)----+------>
\ | | |
`+------+--------'



<----------. or the three-prong switch to select
to charger | charge/ride
<------. |
| o
.-)---o
___/ | o----> to motor field or direction switch
| +| |


Bye.
Jasen
.

Relevant Pages

  • Re: braun oral-b triumph 9500 service manual needed
    ... sounds to me that the battery is going. ... these, and no wires to break, so worth a bit of time to repair. ... Initially checking charger, with DVM Fluke 77 and 1mH small choke ... -ve terminal to charger coil end. ...
    (sci.electronics.repair)
  • Re: braun oral-b triumph 9500 service manual needed
    ... sounds to me that the battery is going. ... these, and no wires to break, so worth a bit of time to repair. ... Initially checking charger, with DVM Fluke 77 and 1mH small choke ... -ve terminal to charger coil end. ...
    (sci.electronics.repair)
  • Re: A real boat related question! Basic 12V electrical stuff....
    ... You don't need to use the switch at all. ... Just attach both fused wires to the hot side of the fuse block. ... > 2) How do I connect the stereo to the battery? ...
    (rec.boats)
  • Re: Moving battery: cable sizing, grounding ?s
    ... to the rear of the vehicle. ... Also you will need a good strong wire to the alternator since that is very very important for charging your battery without loosing volts and efficiency. ... Of course if you ave room, run the 1-2 jumbo wires back to the former battery location, thats simplest. ... The best is to move the whole fuse panel when you move the battery, but I don't know the car to say how well/easy this will be. ...
    (rec.autos.tech)
  • Re: Receptacle and plug
    ... starting battery is usualy dead. ... If I can keep the trickle charger ... receptacle, body to other side of receptacle. ... Look at the wires from the trickle charger that would normally hook to ...
    (alt.home.repair)