Re: Too many amps?
I would add this caveat:
The wall-wart linear style power adapters have very poor regulation
and usually deliver the rated voltage when you're drawing sufficient
current. So using a well-regulated power supply that delivers the
correct voltage, but can deliver more current, is just fine. But
using a poorly regulated one that is too big might deliver more
voltage than you'd expect.
CWatters wrote:
No. What you have is fine.
The spec on the transformer (1.5A) is the maximium that it can deliver.
The spec on the router (1.25A) is the maximium that it will draw from it's
power supply.
The router needs 1.25A max. The power supply can deliver 1.5A so all is OK
.
Relevant Pages
- Re: Choosing ceramic capacitors
... vary from 0.01 GBP to 0.26 GBP. ... thumb the working voltage should ba half the rated voltage. ...
(sci.electronics.design) - Re: Need help with Tantalum polarity
... respect to the polarity of the applied voltage). ... Put the two caps in a protective enclosure. ... > I cannot test these at the rated voltage as I do not have a 35V supply. ...
(sci.electronics.basics) - Re: Choosing ceramic capacitors
... vary from 0.01 GBP to 0.26 GBP. ... thumb the working voltage should ba half the rated voltage. ... The X7R material is less voltage and temperature dependent if both materials ...
(sci.electronics.design) - Re: Choosing ceramic capacitors
... vary from 0.01 GBP to 0.26 GBP. ... thumb the working voltage should ba half the rated voltage. ... The X7R material is less voltage and temperature dependent if both materials ...
(sci.electronics.design) - Re: electrocution by car battery
... >change in current for a 7500V change in voltage across the load from ... transformers and "oil burner" transformers. ... of rated voltage to rated current I find voltage and current typically ... around 60-66% of the "label" values. ...
(sci.electronics.basics) |
|
