Summing non inverting op amp.

Hi,
I've a voltage change 3-4 Volts which I need to change into a 0 to 4
Volt signal.
I have used an inverting op-amp with a virtual ground to give a
cracking result but unfortunately the voltage is going the wrong way
(decreasing instead of increasing.

I have changed to circuit over to be a non inverting amplifier but I'm
worried about the virtual ground. I've been told that summing in a non
inverting op amp can be difficult.
I took the series resistors out of the circuit from my virtual ground
(created from a pot) and from the voltage that I'm amplifying. I have
a 560K feedback and 220K to ground giving me a gain of around 3.5.

Will I have problems with the virtual ground being amplified to or any
other problems?

Many thanks in advance.

David

.

Relevant Pages

  • Re: Summing non inverting op amp.
    ... I've a voltage change 3-4 Volts which I need to change into a 0 to 4 ... I have changed to circuit over to be a non inverting amplifier but I'm ... worried about the virtual ground. ...
    (sci.electronics.misc)
  • Re: Analyzing Stub Matching with Reflection Coefficients
    ... But it's a virtual ground only under specific conditions: ... He was driving an inverting op amp circuit with a square wave, and he was seeing sharp pulses at the "virtual ground" summing junction with his 'scope. ... I tried to explain to him how a "virtual ground" was created: An input signal initially generates a voltage at the op amp input. ...
    (rec.radio.amateur.antenna)
  • Re: Analyzing Stub Matching with Reflection Coefficients
    ... produce a small voltage and large current. ... that the voltage is zero and the current is large. ... usefulness of the idea of a "virtual ground" at the inverting input of ... He was driving an inverting op amp ...
    (rec.radio.amateur.antenna)
  • Re: simple output filter question
    ... I want to make a simple lowpass output filter. ... is an inverting buffer of the RC filter. ... stage with small R in the inverting op amp config. ... I didn't use the term Virtual ground in the graphic because it was too much trouble to draw all that stuff. ...
    (sci.electronics.basics)
  • Re: Question - Phil might know...
    ... The inverting input. ... which case the virtual ground is the result of feedback, ... For an output voltage of 10V rms the voltage on the - input (in an inverting ... The expression you're looking for is negative feedback. ...
    (rec.audio.tubes)