Re: Broken/Fried Parallel port...


CheapscateDave wrote:
lmcgill2@xxxxxxxx wrote:
Hello all, I have been working with an interfacing project lately and I
think I have "screwed up" my parallel port. When trying to read data
from the data register (set from an A/D converter) I wasn't getting
correct results. After some "experimenting" I realized one of the pins
isn't going "high" when being supplied voltage.
Is this a data pin or a status pin on the port that you are attempting
to read?
Anyway, it seems if I
connect this pin directly to the +5 from the 7805 regulator it goes
high, but the A/D converter IC doesn't seem to se the pin high.
I would not connect the 5V direct as this will cause problems is the
device is at a low level. It is better to use a 1K resistor tied to the
5V as a pull up.
I use a
multimeter and figured that this pin needs at leats 18mA to go high
while all the others need about 2 (maybe less).
A 1K resistor to 5V is 5MA and should be sufficient. I suspect the port
is not set to input mode if you are using a data bit.
SO, my question is, is
this normal? Do specific pins on a parallel port act that differently
from eachother or have I fried something inside my laptop?
Data pins are different from Status pins and some status pins have
inverted levels.
my port still works, I just altered its functionality. So how could I
use my A/D converter to throw this malfunctioning parallel port pin
high? Could I use a transistor (2N3904?!?) somehow? Any help would be
excellent.
I don't have my chart handy, please indicate what Pin numbers you are
using.



Thanks Dave for the help, I am trying to read from the data register.
To my knowledge, the 0-bit of the data register is pin 2 on the
parallel port, and the 7-bit is pin 9. The pin that is giving me wierd
results is pin 8. When i say wierd i mean it won't go "high" when
being told to do so by my ADC IC. In addition, my port is in
bi-direction mode, thanks, Lucas.

.

Relevant Pages

  • Re: OT: DOS programming EPP
    ... There seems to be *no* specifications or equivalent circuits for the parallel port as implemented on the ASICs used in modern PCs. ... it is completely unknown as to the maximum safe sink current to a logic low pin or the maximum source current from a logic high pin. ... The EPP page assumes you did. ... This way of programming was used by the old "standard" printer interface. ...
    (sci.electronics.design)
  • Broken/Fried Parallel port...
    ... isn't going "high" when being supplied voltage. ... but the A/D converter IC doesn't seem to se the pin high. ... Do specific pins on a parallel port act that differently ...
    (sci.electronics.misc)
  • Re: Broken/Fried Parallel port...
    ... but the A/D converter IC doesn't seem to se the pin high. ... Do specific pins on a parallel port act that differently ... Some of the printer port pins can be programmed to be either inputs or ...
    (sci.electronics.misc)
  • Re: OT: DOS programming EPP
    ... >eXplicitly shows how to program a parallel port in the EPP mode, ... > However, no matter what i do, the nominally input printer pins (pin 1 ... >parallel port as implemented on the ASICs used in modern PCs. ... think you can just use DOS shell commands. ...
    (sci.electronics.design)
  • Re: OT: DOS programming EPP
    ... >>> parallel port as implemented on the ASICs used in modern PCs. ... >>> to a logic low pin or the maximum source current from a logic high pin. ... The EPP page assumes you did. ... This way of programming was used by the old "standard" printer interface. ...
    (sci.electronics.design)