Re: motor starting relay


"Maxwell" <luv2fly99@xxxxxxx> wrote in message
news:FIPuh.54090$oA1.2503@xxxxxxxxxxxxxxx

It is a big motor indeed, but I never considered it would take that much
to switch off the starting cap. If it's going to be that expensive, I'd
probably be better off buying a new three phase motor. But thanks for the
help Homer.

I'm assuming it works off a pressure switch?

A contactor is the sort of thing with little resale value. Look around junk
yards and the like - you'll probably find one for $1. You'll pay more for
the timer!

--
..
..
..
..
..
..
..
..



.

Relevant Pages

  • Re: Hissing TV.
    ... Anyway I cleaned up around the cap a bit untill I did not get ... So how do I make it work from cold, ie no blurred picture. ... tube, unbalancing it, I though maybe if I cleaned all of the ... It is when it has been switch on after a long period off that it ...
    (sci.electronics.repair)
  • Re: 66 Princeton Reverb
    ... all is about the ground switch/death cap. ... on-off-on switch. ... wire gets its own lug and bolt to the chassis, ... Under no circumstances should the amp be powered up without a load on the ...
    (alt.guitar.amps)
  • Re: Understanding Charge Pumps
    ... Switch A - from 5V to C1 ... Flying cap is connected between C1 and C2 ... Assume ideal swiches - this is the part of the cycle where the cap is ... You mention the current that is used to replace the charge lost when ...
    (sci.electronics.design)
  • Re: Tech: How to improve stationary target performance on early Bally SS machines?????
    ... stationary targets are hit too hard and too fast then they don't score ... (the switch contacts are clean, ... This won't short the connection it will just allow the cap to hold the ...
    (rec.games.pinball)
  • Re: Tech: How to improve stationary target performance on early Bally SS machines?????
    ... stationary targets are hit too hard and too fast then they don't score ... (the switch contacts are clean, ... This won't short the connection it will just allow the cap to hold the ...
    (rec.games.pinball)
Loading