Re: aiwa cd tray removal

From: Mark D. Zacharias (mzacharias_at_yis.us)
Date: 06/21/04 

Date: Mon, 21 Jun 2004 04:57:56 -0500

There's a couple release tabs at the rear underside edge of the tray, near
the corners. Problem is, you may have a real problem getting the mechanical
timing correct on re-assembly.

Mark Z. 

-- 
Please reply only to Group. I regret this is necessary. Viruses and spam
have rendered my regular e-mail address useless.
"Dave Botsch" <dwb7@cornell.edu> wrote in message
news:pan.2004.06.21.03.15.58.624882@cornell.edu...
> Hi, folks.
>
> Have an AIWA NSX-V70 mini cd system (just got back from the class action
> lawsuit repair on the cd mechanism refusing to play cds --worked great
> for the past couple of weeks). Unfortunately, it appears that the belt
> which causes the cd tray to turn came loose. If I eject the tray, I can
> just see the loose belt under it. From what I can tell, the motor is under
> the tray on the left side as you look at the system.
>
> Anyway, I figure that if I can get the tray all the way out, I can get the
> belt back on (or see if there is a broken something else which let the
> blelt come off to begin with... most likely the problem... and then
> perhaps order the right part).
>
> Thing is, I cannot get the tray out. On that left side, something appears
> to be keeping the tray from coming out further then it would during nomral
> operation. I can feel some sort of stop taking place.
>
> Any thoughts on how I can get the tray out?
>
> -- 
> ********************************
> David William Botsch
> dwb7@cornell.edu
> ********************************
>

Relevant Pages

  • Re: CD wont eject
    ... can't change CDs except by partially dismantling the computer to get ... Like a lot of CD drives I think the tray servo motor dives through a small ... rubber belt. ... I tried the rubber band and an 'O' ring but couldn't get the tension ...
    (comp.sys.acorn.hardware)
  • Re: Dell computer DVD RW problem
    ... We recently went to burn an audio CD and the computer doesn't reconize there is a blank in the drive. ... The CD is spinning because when ejected, it's not positioned the same when I place it on the tray. ... many times the little rubber belt that drives the tray and lifts the cd into position slips and doesnt lock into place.Here is my test for a slipping drive belt ...
    (sci.electronics.repair)
  • aiwa cd tray removal
    ... lawsuit repair on the cd mechanism refusing to play cds --worked great ... it appears that the belt ... which causes the cd tray to turn came loose. ... just see the loose belt under it. ...
    (sci.electronics.repair)
  • Re: pc dvd drive problem
    ... well be getting marginal and starting to slip. ... In this case, the tray does ... the easy bit, and slides back in, but then the belt really comes under load, ... This is the time when it really slips, and the loading sequence does not ...
    (sci.electronics.repair)
  • Re: aiwa cd tray removal
    ... you won't be able to just pull the tray out the front. ... "Mark D. Zacharias" wrote in message ... it appears that the belt ...
    (sci.electronics.repair)