Re: Mitsubishi hum & horiz bar

From: sofie (sofie_at_olypen.com)
Date: 06/29/04 

Date: Mon, 28 Jun 2004 22:18:33 -0700

george stringe:
YES, you are probably correct with your diagnosis.
First, check and repair the PS.... could be dry or high esr electrolytics or
defective diode, bridge, regulator semiconductors?
Once you get the PS repaired if you are still having vertical deflection
problems, then check and/or replace the half a dozen or so electrolytics
near and around the vertical output circuitry.
Be certain to check the solder connections near and around the high heat
producing parts.
You might want to go to the website for this newsgroup at
http://www.repairfaq.org/
there, with some search time, you will find a wealth of repair and safety
information.
Good luck with the repair.... 

-- 
Best Regards,
Daniel Sofie
Electronics Supply & Repair
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
"george stringe" <annsmg@comcast.net> wrote in message
news:2085b87b.0406281819.8709a43@posting.google.com...
> Mitsubishi CS-2610R tv has loud hum, 3/4 inch wide horiz bar for a
> picture.  Don't have manual, thinking vert module and/or ps?
>
> thanks

Relevant Pages

  • Re: RCA VR678HF VCR ticking PS
    ... obtain the service kits available from on-line electronics suppliers ... regulation caused by the high ESR electrolytics. ... testing and repair information there.... ...
    (sci.electronics.repair)
  • Re: Mitsubishi hum & horiz bar
    ... check and repair the PS.... ... then check and/or replace the half a dozen or so electrolytics ... I'll put the esr meter on it tomorrow. ...
    (sci.electronics.repair)
  • Re: Kenwood PS-40 switching PS ?
    ... more expensive than just replacing electrolytics or resoldering connections. ... a catastrophic failure of other parts that are stressed by the high ESR ... Electronics Supply & Repair ... >> Daniel Sofie ...
    (sci.electronics.repair)
  • Re: Mitsubishi TV CS-2725 Vertical Problem
    ... More than likely there are faulty, dried up, or otherwise high ESR ... faulty SMD electrolytics and corroded pcb traces would be to blame. ... This is usually not a real expensive repair at most shops. ...
    (sci.electronics.repair)
  • Re: 1990 Sharp TV; vertical is way exagerated
    ... Faulty circuitry in and around vertical output chip circuitry and/or ... Most probably faulty, dry, high ESR electrolytics... ... TAKE it to a repair shop for at the very least a repair cost estimate so you ...
    (sci.electronics.repair)