gateway 700A problem

From: exxos (exxos_at_home.co.uk)
Date: 06/29/04 

Date: Tue, 29 Jun 2004 18:52:29 +0100

Hi all,

I started out with a dead monitor, which kept blowing the line transistor,
changing the trnasistor (and latter LOPT) cured this, though Q719 (mosfet)
went short and was replaced (not by me) with another one, Does anyone know
what mosfet it was since the orig. one is long lost, It had in there a
N-chan FET, though its blown a 1watt resistor connected to it, so I only
assume its supposed to be a P-chan fet, but can anyone tell me what the
origional fet number is ?

TIA,
Chris

Relevant Pages

  • Re: 170VDC to 185VDC boost circuit
    ... What MOSFET are you using in your spice circuit. ... cries out for using a transformer rather than an inductor. ... The FET will switch at much lower currents. ...
    (sci.electronics.design)
  • Re: How to quickly turn on/off N-FET switching high side of 55V?
    ... MOSFET dies sizes by comparing power dissipation ratings ... Wouldn't power dissipation ratings also be highly dependent on the ... package that the FET was in? ...
    (sci.electronics.design)
  • Re: TRYING to compare bipolar, Fet and Mosfet transistors
    ... Could be said that the FET and MOSFET are transistors of a greater ... amplification capacity than the bipolar but they carry out the same one ...
    (sci.electronics.basics)
  • Re: motor current sense question
    ... >>for the inductor current to continue existing right after the FET ... I have a full-bridge MOSFET, but I am only driving the motor in one ... direction or using half of the bridge. ...
    (sci.electronics.design)
  • Re: Identifying burnt transistor
    ... If + voltage is put on the drain it is an N channel device. ... 5V is not enough to run a regular MOSFET at high currents. ... gain of an FET or tube/valve) costs money. ...
    (sci.electronics.repair)