Re: Fluke 79 -- Is rotary switch supposed to turn past last position?
From: dave (alofusblountmaybe_at_alltel.net)
Date: 07/08/04
- Next message: Tim Kettring: "Re: Central Air Flow Problem"
- Previous message: Penis: "Big"
- In reply to: Tom Del Rosso: "Fluke 79 -- Is rotary switch supposed to turn past last position?"
- Next in thread: Tom Del Rosso: "Re: Fluke 79 -- Is rotary switch supposed to turn past last position?"
- Reply: Tom Del Rosso: "Re: Fluke 79 -- Is rotary switch supposed to turn past last position?"
- Messages sorted by: [ date ] [ thread ]
Date: Wed, 7 Jul 2004 20:30:28 -0400
"Tom Del Rosso" <tdnews01@att.net.invalid> wrote in message
news:44TGc.208650$Gx4.46368@bgtnsc04-news.ops.worldnet.att.net...
> I just discovered that the switch on my Fluke 79 can be turned almost
> 360 degrees. There is a stop preventing it from going CCW past 'Off'
> and from turning CW to 'Off', but no stop preventing CW motion past
> 'Amps'.
>
> Maybe I just never noticed this before? I mean, it doesn't feel broken
> otherwise, and nothing is rattling around. Do others do this?
>
>
> --
> -Reply in group, but if emailing add 2 more zeros-
> -and remove the obvious-
>
>
This happens after some years of use. My 77 does that, doesn't seem to be a
problem.
dave
- Next message: Tim Kettring: "Re: Central Air Flow Problem"
- Previous message: Penis: "Big"
- In reply to: Tom Del Rosso: "Fluke 79 -- Is rotary switch supposed to turn past last position?"
- Next in thread: Tom Del Rosso: "Re: Fluke 79 -- Is rotary switch supposed to turn past last position?"
- Reply: Tom Del Rosso: "Re: Fluke 79 -- Is rotary switch supposed to turn past last position?"
- Messages sorted by: [ date ] [ thread ]
Relevant Pages
|
