Re: Pioneer Turntable PL-117D Platter removal

From: Mark D. Zacharias (mzacharias_at_yis.us)
Date: 08/22/04 

Date: Sun, 22 Aug 2004 06:38:08 -0500

Clean any residue from the platter and motor pulley. If possible clean any
debris from around the motor shaft and appli a bit of light oil where the
shaft enters the motor. It's due after all these years.

Mark Z.

"Boris Mohar" <borism@sympatico.ca> wrote in message
news:ucgfi09q9mitt4nvsg4udb4fkdd5cstvu8@4ax.com...
> On Sat, 21 Aug 2004 15:43:45 -0500, "Mark D. Zacharias"
<mzacharias@yis.us>
> wrote:
>
> >Use an object such as a plastic handled screwdriver. While grabbing the
> >platter by the two finger-holes and pulling up, tap on the center spindle
> >with the plastic handle. Firmly but not too hard. The platter will come
> >right off.
> >
> >Mark Z.
>
> Thank you very much. It took exactly one whack. Anything else I should
> watch out for when replacing the belt?
>
>
>
> Regards,
>
> Boris Mohar
>
> Got Knock? - see:
> Viatrack Printed Circuit Designs http://www3.sympatico.ca/borism/

Relevant Pages

  • Re: Pioneer Turntable PL-117D Platter removal
    ... >Clean any residue from the platter and motor pulley. ... >debris from around the motor shaft and appli a bit of light oil where the ...
    (sci.electronics.repair)
  • Re: Lionel Polar Express questions
    ... and I'm worried we might be damaging the motor. ... Since the loco depends on an electrical connection between the wheels ... easiest thing to do is to simply clean them. ... But the headlamp is lighting up and the locomotive just sits there until I ...
    (rec.models.railroad)
  • Re: 12VDC motor problems
    ... input plug, not in the motor. ... I would suggest that the 3rd brush is wired to another external terminal ... The crane is actually called Chocolate Factory by ... It drops them on a platter and then the platter pushes them ...
    (sci.electronics.basics)
  • Re: Pitch Issues on Rega (Or Any) Turntables
    ... speed of the motor. ... My ideal turntable would be a Sota, belt driven with a Denon motor. ... Rubber belt drives can only pull and require the bearing to ... The fact that the bearing's centre of gravity is above the platter (IOW: ...
    (rec.audio.opinion)
  • Re: Pitch Issues on Rega (Or Any) Turntables
    ... speed of the motor. ... My ideal turntable would be a Sota, belt driven with a Denon motor. ... Rubber belt drives can only pull and require the bearing to ... The fact that the bearing's centre of gravity is above the platter ...
    (rec.audio.opinion)