Re: Mitsubishi TV has a bad cap or two.....

From: dkuhajda (rdkuhajda_at_locl_dot_net_at_locl.net)
Date: 08/29/04 

Date: 28 Aug 2004 23:06:13 -0700

The regulator failure was due to not completing the whole repair the last
couple of times. Capacitor problems are the cause of the regulator
failure. Do not forget to double check the regulator bypass resistor to
see if it has increased in value or opened up.

Welcome to the world of just about every Mitz set from that era, mass
capacitor replacement is required for a proper long term repair. Most
people are not willing to put the kind of money into the set for a good
repair after 7 or so years.

David

Relevant Pages

  • Wiring of multiple wind generators - Larry?
    ... I have had an Aerogen 4 for about 14 years which is in need of repair ... Purchased a new Air-X to replace it but have since decided to repair ... I have an existing regulator for the Aerogen and a rheostat heat sink ...
    (rec.boats.cruising)
  • Re: acetylene gauge pulsating
    ... regulator doing the same thing. ... your fuel gas. ... My Harris torch body needed a new ... vendor will not do a minor repair without a major ...
    (sci.engr.joining.welding)
  • Bally and Stern Solenoid Driver/Regulator Repair Special
    ... me your repairable Bally or Stern regulator/solenoid driver and I'll ... Completely rebuild the high voltage regulator ... Repair up to 5 solenoid driver circuits ...
    (rec.games.pinball)
  • Re: regulator choice ??
    ... Almost all regulator designs keep spring pressure on both the low pressure ... seat and the high pressure seat even when in storage. ... out on a boat and you experience a regulator failure, ... missing a boat trip worth the savings on a regulator service? ...
    (rec.scuba.equipment)
  • Re: regulator choice ??
    ... Almost all regulator designs keep spring pressure on both the low pressure ... seat and the high pressure seat even when in storage. ... out on a boat and you experience a regulator failure, ... missing a boat trip worth the savings on a regulator service? ...
    (rec.scuba.equipment)