Re: APC Back-UPS 280B faulty - looking for ideas

From: dkuhajda (rdkuhajda_at_locl_dot_net_at_locl.net)
Date: 08/30/04

Next message: Fred McKenzie: "Re: Canon Inkjet"
Previous message: dkuhajda: "Re: unlocking radio"
In reply to: Jeff Wiseman: "Re: APC Back-UPS 280B faulty - looking for ideas"
Next in thread: Asimov: "APC Back-UPS 280B faulty - looking for ideas"
Messages sorted by: [ date ] [ thread ]

Date: 29 Aug 2004 22:20:14 -0700

FYI if you plan on using it on any kind of motor or inductive load, you
need a different UPS. The APC units for computers are not designed for use
on any kind of motor or coil, in fact they even state they should not be
used on a heavy resitive load.

Check APC's web site for the specifications of that model.
David

Next message: Fred McKenzie: "Re: Canon Inkjet"
Previous message: dkuhajda: "Re: unlocking radio"
In reply to: Jeff Wiseman: "Re: APC Back-UPS 280B faulty - looking for ideas"
Next in thread: Asimov: "APC Back-UPS 280B faulty - looking for ideas"
Messages sorted by: [ date ] [ thread ]

Relevant Pages

Re: PWM constant current source ... help
... inductive load (a small DC motor). ... But for an inductive load I ... Especially since I'm not familiar at all with the electrical properties of DC motors except that they are inductive (I'm thinking that they behave like a constant inductance in series with a resistor that increases with rpm). ... The voltage stays below the positive supply and does not have the fast, large swings riding on it. ...
(sci.electronics.design)
PWM constant current source ... help
... But for an inductive load I ... I can't put Rs into the top leg of the motor because I can't break ... constant inductance in series with a resistor that increases with rpm). ... The idea is to have a roughly constant-torque setup. ...
(sci.electronics.design)
Re: Need some help
... Here is what I need for my project.I have 2 computers. ... of old using PS/2 Keyboard and mouse and there is a motor controller ... What I need to do is I have to take the measurement ... every time the motor moved. ...
(sci.electronics.design)
Need some help
... I would like to have information about keyboard interface. ... Here is what I need for my project.I have 2 computers. ... every time the motor moved. ... It must control delay time between each position ...
(sci.electronics.design)
Re: Need some help
... Here is what I need for my project.I have 2 computers. ... What I need to do is I have to take the measurement ... every time the motor moved. ... It must control delay time between each position ...
(sci.electronics.design)