Re: white Line
Date: 18 Oct 2004 10:28:42 -0700
Here is the method suggested:
1)Resolder the vertical section (IC,Caps and resistors)
2)Replace all the caps used in the vertical section.
3)Replace the vertical IC if the problem persists.
Good luck.
Jacques
Relevant Pages
- Re: white Line
... 1)Resolder the vertical section (IC,Caps and resistors) ... 2)Replace all the caps used in the vertical section. ... Good luck. ... Jacques ...
(sci.electronics.repair) - Re: Dynaco Mark VI problem : Hum, low B+ and no signal after replacing 22 ohm
... bias rectifier, and the bias smoothing caps, or at least temporarily ... replace the coupling caps on the outputs. ... resistors while running a poor tube. ... Upon running the stock voltage tests, I see I have about 80% B+ ...
(rec.audio.tubes) - Re: Problem with a Fisher 400
... tubes greatly reduce the stress on the entire system as long as the ... Bias Voltage ... Added Trim Resistors are a last resort. ... small-value caps. ...
(rec.audio.tubes) - Re: Paper capacitor and Hallicrafters S-40A notes (resistors too?)
... I replaced all the paper caps. ... new film caps measure right on the ... resistors had changed value considerably. ...
(rec.radio.amateur.boatanchors) - Re: Tech: Tempest and 6100 monitor shakes or jiggles or jumps
... Checked everything on the Tempest below except the Zener diodes in the HV section, the resistor on the ARII board, and the ..47uf caps on the Deflection board. ... Correct resistors were in stalled at R710 and R610. ...
(rec.games.video.arcade.collecting) |
|
