Re: Need part # for caps

From: Eugen T (viperz_at_pleasedontspam.com)
Date: 10/30/04 

Date: Sat, 30 Oct 2004 18:52:28 -0400

Why don't you get similar caps? i.e. ones rated at higher voltage, not
necessarily same (but close) capacitance.

"HEC Service" <siggy62b@hotmail.com> wrote in message
news:46d7o012gq5d2bg1gdl0sd6np41pp6s6hm@4ax.com...
>
> Hello,
>
> I'm working on a JVC model # RX-507TVN stereo receiver.
> There isn't any parts list for it on the JVC website.
> I email technical assistance and was told to buy the service manual.
> Can anyone supply the part number for C806/807. These two caps
> are each electolytics 8700uf @ 63v.
> I'm stuck with JVC since none of my suppliers has this value of cap.
>
> Thankyou,
>
>

Relevant Pages

  • Re: placing addiional caps across existing caps to reduce noise
    ... I understand about different caps working better at different ... I just don't see the benefit of smaller capacitance values. ... Rick's teacher has presented a way to prevent resonances between bypass ... high Q of the plane capacitance. ...
    (comp.arch.fpga)
  • Re: Size of power supply capacitors
    ... Haflers have a significant sag with the power supplies. ... bigger caps will sound like a bigger amp. ... If you have enough capacitance, ...
    (rec.audio.pro)
  • Re: Capacitor self-resonant freq question
    ... X7R is IIRC +/-15% over its temperature range, NPO is close to ... increase the voltage across the cap, its capacitance drops. ... If you only ever use NPO caps, that limits you to about 1nF or so. ... > impedance goes up with frequency, looking like an inductor, I thought ...
    (sci.electronics.design)
  • Re: Line filtering
    ... Then do a reasonabole model of the DC bus caps, so you have a reasonable idea of the ripple voltage. ... Because EMC is all about parasitics, I pick the lowest allowable level, and use that to design the filter. ... inductor end-to-end capacitance is hugely important - a massive inductor does naff all at EMC frequencies because of this capacitance, which is dominated by the start wire and the final layer of turns + the finish wire. ...
    (sci.electronics.design)
  • Re: placing addiional caps across existing caps to reduce noise
    ... does not reduce the noise (unless the dominant cause is lack of adequate ... Many times people have placed additional caps on top of the the existing ... amount of additional capacitance. ... I can TDR the planes. ...
    (comp.arch.fpga)