Re: RCA F27351WN CTC177BE Has no color. Black and white p

From: Radford (rwilliam_at_radford.edu)
Date: 11/29/04 

Date: Mon, 29 Nov 2004 11:32:40 -0500

I looked at the 3.58 MHz crystal which did not have a signal on it. The
voltage seemed fine at 3.6V Forgot to mention that the display seemed to
be washed out. Not a good Black and white image. Had the user bring me the
remote to the set and access the menu. There was color in the menu! At
this time I hit reset in the menu and now the set has color. The picture
is fine!!! I am at a total lose as to what happen to this set to cause
this kind of problem. The user said that the set made a POP sound when he
turn it on and would not turn on after that. Let me thank everybody for
there help and suggestion. Has anybody seen this type of problem resolve
by resetting the settings?

Relevant Pages

  • Re: Help with Display problem
    ... they would put a winding in just for this voltage and then double it ... >>> I have a Sony DTC 700 DAT tape transport that the display has gone blank ... >> The AC voltage is for the heated cathode wires, ... IIRC you need about 30v on the anodes (display segments) to light ...
    (sci.electronics.repair)
  • Re: Teac RW-D280 CD recorder - very dim fluorescent display
    ... - perhaps 300 hours or so, so I'm hoping the problem isn't the display ... Typical supply voltage is around 1.5 to 3v AC for the filament supply ... As electrolytic caps are not really designed to have low ... Also with a switcher, the AC ...
    (sci.electronics.repair)
  • Re: Teac RW-D280 CD recorder - very dim fluorescent display
    ... - perhaps 300 hours or so, so I'm hoping the problem isn't the display ... Typical supply voltage is around 1.5 to 3v AC for the filament supply ... As electrolytic caps are not really designed to have low ... Also with a switcher, the AC ...
    (sci.electronics.repair)
  • Re: Teac RW-D280 CD recorder - very dim fluorescent display
    ... - perhaps 300 hours or so, so I'm hoping the problem isn't the display ... Typical supply voltage is around 1.5 to 3v AC for the filament supply ... As electrolytic caps are not really designed to have low ... Also with a switcher, the AC ...
    (sci.electronics.repair)
  • Re: Tech: System 11 display PS question
    ... They expect a minimum of 170 volt differential and a maximum of 200 ... At the entry into the display board, they dropped the positive voltage by ... Your two 87 volt zeners would put the power to the display board at 174 ...
    (rec.games.pinball)