Re: Sansui cd-x711 cd-player several problems!
From: Erik (erik.eketorp_at_home.se)
Date: 12/05/04
- Next message: JURB6006: "Re: Non-polarised electrolytic capacitors needed!"
- Previous message: Fred: "Re: Olympus C-700 Service Manual or Schematic?"
- In reply to: Erik: "Sansui cd-x711 cd-player several problems!"
- Next in thread: Mark D. Zacharias: "Re: Sansui cd-x711 cd-player several problems!"
- Reply: Mark D. Zacharias: "Re: Sansui cd-x711 cd-player several problems!"
- Messages sorted by: [ date ] [ thread ]
Date: 5 Dec 2004 14:33:21 -0800
I forgot to mention that I checked all leads to pickup and motor, they
are ok. However, there is no voltage at the terminal the motor
connects to, probably the same thing for the coils at the
trackingdevice connection. When it tries to focus, I can see a dim red
light, apparently the laser is ok. There are a couple of boards in the
unit, but in this case I think a part of the RF/SERVO(f) board is
likely to be failing, the board is in two parts, the part where both
the motor and tracking connects to is a vertical mounted little board
on the larger mainboard, where the other cables from the pickup goes
to.
Hope you can help me on this one.
Thanks in advance, Erik
- Next message: JURB6006: "Re: Non-polarised electrolytic capacitors needed!"
- Previous message: Fred: "Re: Olympus C-700 Service Manual or Schematic?"
- In reply to: Erik: "Sansui cd-x711 cd-player several problems!"
- Next in thread: Mark D. Zacharias: "Re: Sansui cd-x711 cd-player several problems!"
- Reply: Mark D. Zacharias: "Re: Sansui cd-x711 cd-player several problems!"
- Messages sorted by: [ date ] [ thread ]
Relevant Pages
|
