HV shutdown

From: BigTom (me_at_my.net)
Date: 12/22/04

Next message: hrhofmann_at_att.net: "Re: WB 140 clock motor needed"
Previous message: Mike: "Re: Extending the life of a camcorder through refrigeration?"
Next in thread: Jerry G.: "Re: HV shutdown"
Reply: Jerry G.: "Re: HV shutdown"
Messages sorted by: [ date ] [ thread ]

Date: Thu, 23 Dec 2004 02:10:08 +1100

Mitac L1450PD monitor

i get HV for about half a second then it shuts down.
heater glows orange 6v at crt neck.
G1 and G2 drop to 0v after shutdown.
HOT ok.
removed HOT and placed a 240v 40w globe across collector and gnd.
lamp lights up.
i measured B+ at one of the caps on the secondary side of the chopper
and get 152v.
is this a good place for B+ and is this voltage too high?

Next message: hrhofmann_at_att.net: "Re: WB 140 clock motor needed"
Previous message: Mike: "Re: Extending the life of a camcorder through refrigeration?"
Next in thread: Jerry G.: "Re: HV shutdown"
Reply: Jerry G.: "Re: HV shutdown"
Messages sorted by: [ date ] [ thread ]

Relevant Pages

Re: Video Problem
... little bit blurry for a fraction of a second every few ... Is this most likely the monitor or the video card? ... from the anode cap on top of the CRT, or possibly from the CRT neck ...
(alt.comp.hardware.pc-homebuilt)
Re: Zeroeth level pc monitor repair
... > to the subboard fixed to the CRT neck socket close by to spark gaps and HV ... VGA signals are not TTL level, they are analogue 75 Ohm video signals. ... > Does a recent pc monitor with DDC control lines need a more recent pc? ...
(sci.electronics.repair)
Re: HP Pavilion MX70 Video Monitor case removal problem
... If your HP monitor is like the one I'm working on, ... clips on each side. ... Find the small rectangular holes on each side and ... > region of the crt neck. ...
(comp.sys.hp.hardware)