Re: Sharp Microwave powers down after 40 seconds, need assistance
From: electroninja (cnctutwiler_at_wmconnect.com)
Date: 01/09/05
- Next message: Rich Grise: "Re: Delay on a mains-powered relay?"
- Previous message: Leonard Caillouet: "Re: TV EEPROM data files"
- In reply to: Harry Hotspur: "Re: Sharp Microwave powers down after 40 seconds, need assistance"
- Next in thread: electroninja: "Re: Sharp Microwave powers down after 40 seconds, need assistance"
- Reply: electroninja: "Re: Sharp Microwave powers down after 40 seconds, need assistance"
- Reply: Franc Zabkar: "Re: Sharp Microwave powers down after 40 seconds, need assistance"
- Messages sorted by: [ date ] [ thread ]
Date: 9 Jan 2005 08:36:24 -0800
Sam--the contoller board has a hardwired LC6041 chip. My spare parts
microwave has the same chip and it works. Ever tried to unsolder a 48
pin LC without damaging it thru overheating?
Harry--this unit has only one thermal cutoff switch physically mounted
on the casing surrounding the magnetron--electrically it is upstream of
all loads and were it to activate it would shutdown everything (lights,
fans, control display.. etc)--which is not the case here. Thoughts?
Thanks for all comments--
- Next message: Rich Grise: "Re: Delay on a mains-powered relay?"
- Previous message: Leonard Caillouet: "Re: TV EEPROM data files"
- In reply to: Harry Hotspur: "Re: Sharp Microwave powers down after 40 seconds, need assistance"
- Next in thread: electroninja: "Re: Sharp Microwave powers down after 40 seconds, need assistance"
- Reply: electroninja: "Re: Sharp Microwave powers down after 40 seconds, need assistance"
- Reply: Franc Zabkar: "Re: Sharp Microwave powers down after 40 seconds, need assistance"
- Messages sorted by: [ date ] [ thread ]
Relevant Pages
|