Re: I killed my Hitachi 28" widescreen ;-(

From: mcare1 (duffname_at_hotmail.com)
Date: 01/22/05


Date: 22 Jan 2005 09:06:50 -0800

This could have been a nice easy fault

not in the psu,

but there is a metal heat sink down the centre of the pcb, resolder all
of the parts of this only 2 or 3 transistor and a frame ic , normally
dry joint on these parts

if you resoldered the psu just maybe a case of replacing the chopper
transistor and or ic

good luck



Relevant Pages

  • Re: I killed my Hitachi 28" widescreen ;-(
    ... >but there is a metal heat sink down the centre of the pcb, ... I remember seeing a lasgish one .. ... resolder all ... >if you resoldered the psu just maybe a case of replacing the chopper ...
    (sci.electronics.repair)
  • Re: Need help identifying 8 pin DIP used in Plasma PS PLEASE.
    ... I can't find a datasheet for FA5522. ... I don't understand why a 60V audio frequency power transistor would be ... used on the primary side of a high frequency switchmode PSU. ... used on the primary side of a high frequency switchmode PSU." ...
    (sci.electronics.repair)
  • Re: Dell W3000 power cycles (PS2008 IC)
    ... This transistor was in one of the feedback circuits. ... The wierd thing is all voltages check correct and do not change with the PSU ... power cycles. ... The PSU was hit by a power surge. ...
    (sci.electronics.repair)
  • Re: Philips PM-3323 DSO Blowing Fuses
    ... diode.. ... AFAIR it finally was the EHT transistor that was fried and made the main PSU ... Even if the schematics isn't completly finished, ...
    (sci.electronics.equipment)
  • Re: PNY 6600GT repairable?
    ... The odds are not good that that one transistor that fired is the ONLY part ... Yesterday, i bought a new PSU, a 530w hiper. ... smoke coming from the card. ...
    (alt.comp.hardware.pc-homebuilt)

Quantcast