Re: High Voltage Check

From: NSM (nowrite_at_to.me)
Date: 03/14/05 

Date: Mon, 14 Mar 2005 20:22:28 GMT

"ri" <rijo1@REMOVEnemonet.com> wrote in message
news:4235AF9A.C16EC99A@REMOVEnemonet.com...
> Hi Group , all I am working with here is the High Voltage Transformer
> itself . The rest of the microwave oven has been discarded as trash . I
> need a transformer that has an output of 1,500 volts for use as a plate
> transformer . I have several microwave transformers to test .
> This brings me back to the question of testing the voltage . How is the
> best way to check the voltage?

Very, very, very, very, very, very, very, very, very, very, very, very
carefully.

Don't even THINK of touching any part of the multimeter while testing.

N

Relevant Pages

  • Re: A8N-SLI low voltage readings
    ... > Here are my voltage readings with an Antec Neopower 480. ... > +12 Volts reads as 11,78 ... correct value, when they are measured by my $100 multimeter, ... The measurement error on the motherboard consists of two parts. ...
    (alt.comp.periphs.mainboard.asus)
  • Re: High Voltage Check
    ... all I am working with here is the High Voltage Transformer ... I would clip several USM-6's in series ... an _honorable_ discharge instead of receiving some sort of _other_ discharge. ...
    (sci.electronics.repair)
  • Re: High Voltage Check
    ... all I am working with here is the High Voltage Transformer ... account of losses. ... Got a DMM with a decent inductance range? ...
    (sci.electronics.repair)
  • Re: He who laugh last, laughs loudest, was Re: Wet your pants funny-- A.J. as an EE
    ... if you look at the LM675 spec sheet it shows 90db of power supply ... If the power supply voltage varies ... going to get 60 volts peak-to-peak out, which is about 20 volts RMS ... So this added resistor has used up all the IC's power ...
    (rec.audio.tubes)
  • Re: PMOS in parallel with NMOS
    ... Connect 5 volts directly to the emitter. ... The 0 volts on the base is provided by a microcontroller pin. ... happens to come from an LM7805 voltage regulator. ... I am not as worried about the LEDs as I am the MCU. ...
    (comp.arch.embedded)